# Question: The figure shows a fluid pressure linear actuator

The figure shows a fluid-pressure linear actuator (hydraulic cylinder) in which D = 4 in, t = 3/8 in, L = 12 in, and w = ¾ in. Both brackets as well as the cylinder are of steel. The actuator has been designed for a working pressure of 2000 psi. Six 3/8 -in SAE grade 5 coarse-thread bolts are used, tightened to 75 percent of proof load.

**View Solution:**## Answer to relevant Questions

The figure shows a bolted lap joint that uses SAE grade 8 bolts. The members are made of cold-drawn AISI 1040 steel. Find the safe tensile shear load F that can be applied to this connection if the following factors of ...Standard design practice, as exhibited by the solutions to Probs. 8–39 to 8–43, is to assume that the bolts, or rivets, share the shear equally. For many situations, such an assumption may lead to an unsafe design. ...The figure shows a bolted lap joint that uses SAE grade 8 bolts. The members are made of cold-drawn AISI 1040 steel. Find the safe tensile shear load F that can be applied to this connection if the following factors of ...Given the following functions F(s) find f(t) F(s) = s2 + 7s + 12 / (s + 2) (s + 4) (s + 6) F(s) = 10(s + 2) / (s2 + 4s + 5)Given the following functions F(s) find f(t) F(s) = s2 / (s + 1) 2 (s + 20) F(s) = s2 + 9s 20/ s(s + 4)2(s + 5)Post your question