# Question: The galvanometer in Exercise 40 is to be used in

The galvanometer in Exercise 40 is to be used in a voltmeter with a full-scale reading of 15 V.

(a) Should you use (1) a shunt resistor, (2) a zero resistor, or (3) a multiplier resistor? Why?

(b) What is the required resistance for your answer choice in part (a)?

(a) Should you use (1) a shunt resistor, (2) a zero resistor, or (3) a multiplier resistor? Why?

(b) What is the required resistance for your answer choice in part (a)?

## Relevant Questions

A galvanometer with a full-scale sensitivity of 600 μA and a coil resistance of 50-Ω is to be used to build an ammeter designed to read 5.0 A at full scale. What is the required shunt resistance? In Exercise 46, suppose instead that the ammeter is connected in series with the resistor and that the volt-meter is placed across both the ammeter and the resistor. (a) Sketch this circuit (with instruments connected) and ...Nine resistors, each of value R, are connected in a “ladder” fashion, as shown in Fig. 18.42. (a) What is the effective resistance of this network between points A and B? (b) If R = 10 Ω and a 12.0-V battery is ...A length of wire with a resistance R is cut into two equal-length segments. These segments are then twisted together to form a conductor half as long as the original wire. (a) The resistance of the shortened conductor is ...A 200-turn circular coil of wire has a radius of 10.0 cm and a total resistance of . At its center the magnetic field strength is 7.45 mT. (a) Determine the voltage of the power supply creating the current in the coil. (b) ...Post your question