# Question: The output piston of a hydraulic press has a cross sectional

The output piston of a hydraulic press has a cross-sectional area of 0.25 m2.

(a) How much pressure on the input piston is required for the press to generate a force of 1.5 x 106 N?

(b) What force is applied to the input piston if it has a diameter of 5.0 cm?

(a) How much pressure on the input piston is required for the press to generate a force of 1.5 x 106 N?

(b) What force is applied to the input piston if it has a diameter of 5.0 cm?

**View Solution:**## Answer to relevant Questions

A hydraulic lift in a garage has two pistons: a small one of cross-sectional area 4.00 cm2 and a large one of cross-sectional area 250 cm2. (a) If this lift is designed to raise a 3500-kg car, what minimum force must be ...(a) If the density of an object is exactly equal to the density of a fluid, the object will (1) float, (2) sink, (3) stay at any height in the fluid, as long as it is totally immersed. (b) A cube 8.5 cm on each side has a ...A 250-N force is applied at a 37o angle to the surface of the end of a square bar. The surface is 4.00 cm on a side. What are (a) The compressional stress and (b) The shear stress on the bar? An ideal fluid is moving at in a section of a pipe of radius 0.20 m. If the radius in another section is 0.35 m, what is the flow speed there? In Conceptual Example 9.14, it was explained why a stream of water from a faucet necks down into a smaller cross-sectional area as it descends. Suppose at the top of the stream it has a cross-sectional area of 2.0 cm2, and a ...Post your question