Question: To make VLANs work configuration
To make VLANs work, configuration tables are needed in the switches and bridges. What if the VLANs of Fig. 4-49(a) use hubs rather than multi drop cables? Do the hubs need configuration tables, too? Why or why not?
Answer to relevant QuestionsIn Fig. 4-50 the switch in the legacy end domain on the right is a VLAN-aware switch. Would it be possible to use a legacy switch there? If so, how would that work? If not, why not?Consider the following design problem concerning implementation of virtual-circuit service. If virtual circuits are used internal to the subnet, each data packet must have a 3-byte header and each router must tie up 8 bytes ...For hierarchical routing with 4800 routers, what region and cluster sizes should be chosen to minimize the size of the routing table for a three-layer hierarchy? A good starting place is the hypothesis that a solution with k ...Consider the Chord circle of Fig. 5-24. Suppose that node 10 suddenly goes on line. Does this affect node 1's finger table, and if so, how?The network of Fig. 5-37 uses RSVP with multicast trees for hosts 1 and 2 as shown. Suppose that host 3 requests a channel of bandwidth 2 MB/sec for a flow from host 1 and another channel of bandwidth 1 MB/sec for a flow ...
Post your question