# Question: Two quality control technicians measured the surface finish of a

Two quality control technicians measured the surface finish of a metal part, obtaining the data in Table 4E.1. Assume that the measurements are normally distributed.

(a)Test the hypothesis that the mean surface finish measurements made by the two technicians are equal. Use a = 0.05 and assume equal variances.

(b) What are the practical implications of the test in part (a)?

(c) Assuming that the variances are equal, construct a 95% confidence interval on the mean

difference in surface-finish measurements.

(d) Test the hypothesis that the variances of the measurements made by the two technicians are equal. Use What are the practical implications if the null hypothesis is rejected?

(e) Construct a 95% confidence interval estimate of the ratio of the variances of technician measurement error.

(f) Construct a 95% confidence interval on the variance of measurement error for technician 2.

(g) Does the normality assumption seem reasonable for the data?

(a)Test the hypothesis that the mean surface finish measurements made by the two technicians are equal. Use a = 0.05 and assume equal variances.

(b) What are the practical implications of the test in part (a)?

(c) Assuming that the variances are equal, construct a 95% confidence interval on the mean

difference in surface-finish measurements.

(d) Test the hypothesis that the variances of the measurements made by the two technicians are equal. Use What are the practical implications if the null hypothesis is rejected?

(e) Construct a 95% confidence interval estimate of the ratio of the variances of technician measurement error.

(f) Construct a 95% confidence interval on the variance of measurement error for technician 2.

(g) Does the normality assumption seem reasonable for the data?

**View Solution:**## Answer to relevant Questions

Suppose that x1 ~ N(1, 12) and x2 ~ N(2, 22), and that x1 and x2 are independent. Develop a procedure for constructing a 100(1 − )% confidence interval on 1 − 2, assuming that 12 and 22 are ...Two processes are used to produce forgings used in an aircraft wing assembly. Of 200 forgings selected from process 1, 10 do not conform to the strength specifications, whereas of 300 forgings selected from process 2, 20 are ...Consider the hypotheses H0 : 0 H1 : 0 where 2 is known. Derive a general expression for determining the sample size for detecting a true mean of 1 0 with probability 1 − if the type I ...Compare the mean etch uniformity values at each of the C2F6 flow rates from Exercise 4.33 with a scaled t distribution. Does this analysis indicate that there are differences in mean etch uniformity at the different flow ...Plot the residuals from Problem 4.44 and comment on model adequacy.Post your question