# Question

Use the data in Exercise 12.9 to construct a bounded adjustment chart. Use = 0.2 and set L = 4. How does the bounded adjustment chart perform relative to the integral control adjustment procedure in part (a) of Exercise 12.9?

## Answer to relevant Questions

Consider the data in Table 12.1. Construct a bounded adjustment chart using = 0.3 and L = 10. Compare the performance of this chart to the one in Table 12.1 and Figure 12.12. Use the data in Exercise 12.6 to construct a bounded adjustment chart. Use λ = 0.2 and set L = 12. How does the bounded adjustment chart perform relative to the integral control adjustment procedure in part (a) of Exercise ...Set up a 28-4 fractional factorial design. Verify that this is a resolution IV design. Discuss the advantage of a resolution IV design relative to one of lower resolution. Suppose that the specifications require that the surface area must be between 0.3 and 0.6 cm2/g and that the density must be less than 14 g/cm3. Find a set of operating conditions that will result in a product that meets ...Box and Liu (1999) describe an experiment flying paper helicopters where the objective is to maximize flight time. They used the central composite design shown in Table 14E.9. Each run involved a single helicopter made to ...Post your question

0