# Question: Using the information in Problem 14 3 construct a net material

Using the information in Problem 14.3, construct a net material requirements plan using the following on-hand inventory.

In Problem 14.3, The demand for subassembly S is 100 units in week 7. Each unit of S requires 1 unit of T and 2 units of U. Each unit of T requires 1 Unit of V, 2 units of W, and 1 unit of X. Finally, each unit of U requires 2 units of Y and 3 units of Z. One firm manufactures all items. It takes 2 weeks to make S, 1 week to make T, 2 weeks to make U, 2 weeks to make V, 3 weeks to make W, 1 week to make X, 2 weeks to make Y, and 1 week to makeZ.

In Problem 14.3, The demand for subassembly S is 100 units in week 7. Each unit of S requires 1 unit of T and 2 units of U. Each unit of T requires 1 Unit of V, 2 units of W, and 1 unit of X. Finally, each unit of U requires 2 units of Y and 3 units of Z. One firm manufactures all items. It takes 2 weeks to make S, 1 week to make T, 2 weeks to make U, 2 weeks to make V, 3 weeks to make W, 1 week to make X, 2 weeks to make Y, and 1 week to makeZ.

## Answer to relevant Questions

Refer again to Problems 14.3 and 14.4. In addition to 100 units of S. there is also a demand for 20 units of U, which is a component of S. The 20 units of U are needed for maintenance purposes. These units are needed in week ...Given the following product structure, master production Lion schedule, and inventory status (Figure on the shown below) and assuming the requirements for each BOM item is 1: (a) Develop a gross requirements plan for item ...Develop an EOQ solution and calculate total relevant costs for the data in the preceding table. Stockout costs equal $10 per unit.*Holding cost = $2.50/unit/week; setup cost = $150; lead time = 1 week; beginning inventory ...You are scheduling production of your popular Rustic Coffee Table. The table requires a top, four legs, 1/8 gallon of stain, 1/16 gallon of glue, 2 short braces between the legs and 2 long braces between the legs, and a ...What is input-output control?Post your question