# Question: Using the results of Prob 4 9 determine contraction

Using the results of Prob. 4–9, determine the end contraction of the uniformly loaded simply supported beam of appendix Table A–9–7. Assume the left support cannot deflect in the x direction, whereas the right support can.

**View Solution:**## Answer to relevant Questions

The figure shows a cantilever consisting of steel angles size 4 X 4 X ½ in mounted back to back, Using superposition, find the deflection at B and the maximum stress in the beam.The cantilever shown in the figure consists of two structural-steel channels size 3 in, 5.0 lbf/ft. Using superposition, find the deflection at A.A shaft is to be designed so that it is supported by roller bearings. The basic geometry is shown in the figure. The allowable slope at the bearings is 0.001 mm/mm without bearing life penalty. For a design factor of 1.28, ...Consider the simply supported beam with an intermediate load in Appendix A–9–6. Determine the deflection equation if the stiffness of the left and right supports are k1 and k2, respectively.Determine the deflection equation for the steel beam shown using singularity functions. Since the beam is symmetric, write the equation for only half the beam and use the slope at the beam center as a boundary condition. Use ...Post your question