Question: What signal to noise ratio is needed
What signal-to-noise ratio is needed to put a T1 carrier on a 50-kHz line?
Answer to relevant QuestionsWhat is the difference between a passive star and an active repeater in a fiber network?Radio antennas often work best when the diameter of the antenna is equal to the wavelength of the radio wave. Reasonable antennas range from 1 cm to 5 meters in diameter. What frequency range does this cover?A simple telephone system consists of two end offices and a single toll office to which each end office is connected by a 1-MHz full-duplex trunk. The average telephone is used to make four calls per 8-hour workday. The mean ...An ADSL system using DMT allocates 3/4 of the available data channels to the downstream link. It uses QAM-64 modulation on each channel. What is the capacity of the downstream link?A pure sine wave of amplitude A is encoded using delta modulation, with x samples/sec. An output of +1 corresponds to a signal change of +A/8, and an output signal of -1 corresponds to a signal change of -A/8. What is the ...
Post your question