# Question: Why has the PCM

Why has the PCM sampling time been set at 125 µsec?

**View Solution:**## Answer to relevant Questions

What is the percent overhead on a T1 carrier; that is, what percent of the 1.544 Mbps are not delivered to the end user?A pure sine wave of amplitude A is encoded using delta modulation, with x samples/sec. An output of +1 corresponds to a signal change of +A/8, and an output signal of -1 corresponds to a signal change of -A/8. What is the ...Compare the delay in sending an x-bit message over a k-hop path in a circuit-switched network and in a (lightly loaded) packet-switched network. The circuit setup time is s sec, the propagation delay is d sec per hop, the ...Suppose that A, B, and C are simultaneously transmitting 0 bits, using a CDMA system with the chip sequences of Fig. 2-45(b). What is the resulting chip sequence?An upper-layer packet is split into 10 frames, each of which has an 80 percent chance of arriving undamaged. If no error control is done by the data link protocol, how many times must the message be sent on average to get ...Post your question