Question: A hand dryer blows heated air downwards out of the exit duct at a velocity of 4 in/s. The temperature and density of the ambient

A hand dryer blows heated air downwards out of the exit duct at a velocity of 4 in/s. The temperature and density of the ambient air at the inlet are 15 C and 1.23 kg/m ³, while at the outlet it has temperature 35 C and density 1.15 kg/m ³. The blower power is 10.0 W, and the heater power is 715 W. Consider the inlet to be at the large mass of ambient air which has negligible velocity

a) What is the pressure at the outlet?

b) You will be applying the energy equation. Why can you ignore any height differences in this situation?

c) If the specific heat of air C = 1000 J/(kg K), where Δû = C ΔT, find the change in internal energy per unit mass from the inlet to outlet.

d) Find the mass flow rate through the dryer.

Step by Step Solution

★★★★★

3.43 Rating (150 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Given informations At inlet condition inlet temperature Ti 15 c 288 k density i 123 kgm3 a At state ... View full answer

blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

Air at 300 K flows through a duct 50 m long with f = 0.019 . What is the minimum duct diameter which can carry the flow without choking if the entrance velocity is (a) 50 m/s, (b) 150 m/s, and (c)...

Q:

Air at 30?C enters a rectangular duct 1 m long and 4 mm by 16 mm in cross-section at a rate of 0.0004 kg/s. If a uniform heat flux of 500 W/m2 is imposed on both of the long sides of the duct,...

Q:

Air flows with negligible friction through a 4-indiameter duct at a rate of = lbm/s. The temperature and pressure at the inlet are T1 = 800 R and P1 = 30 psia, and the Mach number at the exit is Ma2...

Q:

Find RL for maximum power transfer and the maximum power that can be transferred to the load in the circuit in figure. 1 mA 1 kn 2 mA RL 0.5 kn 1 kn 2 mA +)6 V

Q:

In 2012, Jed James began planting a vineyard. The costs of the land preparation, labor, rootstock, and planting were capitalized. The land preparation costs do not include any nondepreciable land...

Q:

The economic life of an equipment is the life at which the total cost is (a) Average cost (b) Minimum cost (c) Maximum cost (d) None of the above AppendixLO1

Q:

Find a single-case design study and critically analyze it using the questions for critical analysis of single-case research presented at the end of the chapter.

Q:

Swain Enterprises issues a 60-day note for $800,000 to Hill Industries for merchandise inventory. Hill Industries discounts the note at 6%. a. Journalize Swain Enterprises' entries to record: 1. The...

Q:

Write the journal entry for each item 1 Ariel Inc purchases 2,000 shares of its $50 par value common stock for $180,000 cash on June 1. It will hold the shares in the treasury until resold 2. On...

Q:

Include a reflection to the client that discusses the tax recommendations and consequences of your newly chosen energy-friendly initiative. Specifically, you must address the following: Identify the...

Q:

Epiphany Industries is considering a new capital budgeting project that will last for three years. Epiphany plans on using a cost of capital of 12% to evaluate this project. Based on extensive...

Q:

What is the societal impact of supply chain management? Provide a specific example.

Q:

Question 3 (CASE STUDY) Toxic company culture nearly ended her start-up Cadence from Emery School of Coffee, a business that offers coffee-making courses ranging from leisure to professional...

Q:

Case: Rob Parson at Morgan Stanley Should Parsons be promoted? Why or why not? Analyzing, how effective Nasr has been at managing Rob Parson. In retrospect, what could he have done more effectively?...

Q:

The call Marc received was from the sales representative for the Asia and Pacific region at Atlas Mining, a Quebec SME based in Trois-Rivires and specializing in mining equipment. The client had...

Q:

Very often, when formulating an optimization problem, it is convenient to use binary decision variables (variables that can take only the values 0 or 1). Denote the price of a particular SKU during...

Q:

16. Explain the differences and similarities between net present value (NPV) and the internal rate of return (IRR)

Q:

Transform the while loop from the previous exercise into an equivalent for loop (make sure it produces the same output).

Q:

An electric motor draws a current of 16 amp at 110 V. The output shaft delivers a torque of 10 N-m at a speed of 1500 RPM. Determine (a) The electric power transferred. (b) Shaft power. (c) The rate...

Q:

Repeat 14-4-12[BSW] if the reactants enter the chamber at 600oC and 10 atm.

Q:

Producer gas from bituminous coal has the following analysis on molar basis. CH4: 3%; H: 14%; N2: 50.9%; O2: 0.6%; CO: 27%; CO2: 4.5%. It is burned with 30% excess air. Determine the air-fuel ratio...

Q:

The development of the Internet has made many things possible, in addition to downloading music. In particular, it allows an increasing number of people to telecommute, or work from home. Although...

Q:

A USA Today editorial addressed the growth of compensation for corporate CEOs. As an example, quoting a study made by BusinessWeek , USA Today indicated that the pay packages for CEOs have increased...

Q:

Maynards, a regional home improvement store chain located in the Intermountain West, is considering upgrading to a new series of scanning systems for its automatic checkout lanes. Although scanners...

Related Book

Thermodynamics An Interactive Approach 1st edition by Subrata Bhattacharjee