# Question: An chart with three sigma limits has parameters as follows UCL

An chart with three-sigma limits has parameters as follows:

UCL = 104

Center line = 100

LCL = 96

n = 5

Suppose the process quality characteristic being controlled is normally distributed with a true mean of 98 and a standard deviation of8. What is the probability that the control chart would exhibit lack of control by at least the third point plotted?

UCL = 104

Center line = 100

LCL = 96

n = 5

Suppose the process quality characteristic being controlled is normally distributed with a true mean of 98 and a standard deviation of8. What is the probability that the control chart would exhibit lack of control by at least the third point plotted?

**View Solution:**## Answer to relevant Questions

Consider the chart defined in Exercise 6.48. Find the ARL1 for the chart. Thirty samples each of size 7 have been collected to establish control over a process. The following data were collected: (a) Calculate trial control limits for the two charts. (b) On the assumption that the R chart is in ...Components used in a cellular telephone are manufactured with nominal dimension of 0.3 mm and lower and upper specification limits of 0.295 mm and 0.305 mm respectively. The x and R control charts for this process are based ...Michelson actually made 100 measurements on the velocity of light in five trials of 20 observations each. The second set of 20 measurements is shown in Table 6E.28 (a) Plot these new measurements on the control charts ...The diameter of the casting in Figure 6.25 is also an important quality characteristic. A coordinate measuring machine is used to measure the diameter of each casting at five different locations. Data for 20 casting are ...Post your question