# Question

A bolted joint is to have a grip consisting of two ½ -in steel plates and one wide ½ -in American Standard plain washer to fit under the head of the ½ in-13 X 1.75 in UNC hex-head bolt.

(a) What is the length of the thread LT for this diameter inch-series bolt?

(b) What is the length of the grip l?

(c) What is the height H of the nut?

(d) Is the bolt long enough? If not, round to the next larger preferred length (Table A–17).

(e) What is the length of the shank and threaded portions of the bolt within the grip? These lengths are needed in order to estimate the bolt spring rate kb.

(a) What is the length of the thread LT for this diameter inch-series bolt?

(b) What is the length of the grip l?

(c) What is the height H of the nut?

(d) Is the bolt long enough? If not, round to the next larger preferred length (Table A–17).

(e) What is the length of the shank and threaded portions of the bolt within the grip? These lengths are needed in order to estimate the bolt spring rate kb.

## Answer to relevant Questions

A bolted joint is to have a grip consisting of two 14-mm steel plates and one 14R metric plain washer to fit under the head of the M14 ?2 hex-head bolt, 50 mm long. (a) What is the length of the thread LT for this diameter ...RB&W11 recommends turn-of-nut from snug fit to preload as follows: 1/3 turn for bolt grips of 1–4 diameters, 1/2 turn for bolt grips 4–8 diameters, and 2/3 turn for grips of 8–12 diameters. These recommendations are ...The same as Prob. 8–24, except that ½ -in cap screws are used with washers (see Fig. 8–21).A 1-in-diameter hot-rolled AISI 1144 steel rod is hot-formed into an eyebolt similar to that shown in the figure for Prob. 3–74, with an inner 2-in-diameter eye. The threads are 1 in-12 UNF and are die-cut. (a) For a ...The bolted connection shown in the figure is subjected to a tensile shear load of 20 kip. The bolts are SAE grade 5 and the material is cold-drawn AISI 1015 steel. Find the factor of safety of the connection for all possible ...Post your question

0