# Question: Electrical strain gauges were applied to a notched

Electrical strain gauges were applied to a notched specimen to determine the stresses in the notch. The results were ǫx = 0.0021 and ǫy = −0.00067. Find σx and σy if the material is carbon steel.

**View Solution:**## Answer to relevant Questions

An engineer wishes to determine the shearing strength of a certain epoxy cement. The problem is to devise a test specimen such that the joint is subject to pure shear. The joint shown in the figure, in which two bars are ...Using our experience with concentrated loading on a simple beam, Prob. 3–20, consider a uniformly loaded simple beam (Table A–9–7). (a) Show that the stress-to-load equation for a rectangular-cross-section beam is ...The figure illustrates a pin tightly fitted into a hole of a substantial member. A usual analysis is one that assumes concentrated reactions R and M at distance l from F. Suppose the reaction is distributed linearly along ...In Prob. 3–35 the angle has one leg thickness 1/16 in and the other 1/8 in, with both leg lengths 58 in. The allowable shear stress is τall = 12 000 psi for this steel angle. (a) Find the torque carried by each leg, ...For the same cross-sectional area A = s2 = πd2/4, for a square cross-sectional area shaft and a circular cross-sectional area shaft, both of length l, in torsion which has the greater angular twist θ, and by what ...Post your question