Question 2 In a steam plant, the steam leaves the boiler at 2.0 MN/m and at...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
Question 2 In a steam plant, the steam leaves the boiler at 2.0 MN/m and at a temperature of 250 °C. it is then expanded in an engine and finally exhausted into a condenser. The pressure and the condition of the steam at entry to the condenser are 14 KN/m and 0.82 dry, respectively. Assuming the whole of the enthalpy drop is converted into useful work in the engine. Determine, a) The power developed for the steam flow of 15 000 kg/h b) The thermal efficiency of the engine if the feed temperature is 50 °C Estimate the mass of cooling water circulated in the condenser /kg of steam condensed, if the cooling water enters at 18 °C and leaves at 36 °C and the condensates leaves at 50 °C. how much energy is lost from the condensate/h due to its being cooled below the saturation temperature corresponding to the condenser pressure. [3.055 MW, 27.3%, 26.1 kg/kg steam, 156000 kJ/h] Question 2 In a steam plant, the steam leaves the boiler at 2.0 MN/m and at a temperature of 250 °C. it is then expanded in an engine and finally exhausted into a condenser. The pressure and the condition of the steam at entry to the condenser are 14 KN/m and 0.82 dry, respectively. Assuming the whole of the enthalpy drop is converted into useful work in the engine. Determine, a) The power developed for the steam flow of 15 000 kg/h b) The thermal efficiency of the engine if the feed temperature is 50 °C Estimate the mass of cooling water circulated in the condenser /kg of steam condensed, if the cooling water enters at 18 °C and leaves at 36 °C and the condensates leaves at 50 °C. how much energy is lost from the condensate/h due to its being cooled below the saturation temperature corresponding to the condenser pressure. [3.055 MW, 27.3%, 26.1 kg/kg steam, 156000 kJ/h]
Expert Answer:
Related Book For
Thermodynamics for Engineers
ISBN: ?978-1133112860
1st edition
Authors: Kenneth A. Kroos, Merle C. Potter
Posted Date:
Students also viewed these mechanical engineering questions
-
In a steam power plant 1 MW is added in the boiler, 0.58 MW is taken out in the condenser and the pump work is 0.02 MW. Find the plant thermal efficiency. If everything could be reversed find the...
-
In steam power plants, open feed water heaters are frequently utilized to heat the feed water by mixing it with steam bled off the turbine at some intermediate stage. Consider an open feed water...
-
Cooling water leaves the condenser of a power plant and enters a wet cooling tower at 35oC at a rate of 100 kg/s. The water is cooled to 22oC in the cooling tower by air which enters the tower at 100...
-
Given that a quantity Q(t) is described by the exponential growth function Q(t) = 400e0.01t where t is measured in minutes, answer the following questions. (a) What is the growth constant k? k = (b)...
-
The temperature of an airstream is to be measured, but the thermometer available does not have a sufficiently high range. Accordingly, a dampened cover is placed around the thermometer before it is...
-
(a) Using the pKa values of the hydrocarbons and ammonia, estimate the equilibrium constant for (1) the reaction in Eq. 14.22 and (2) the analogous reaction of an alkane with amide ion. Eq. 14.22 (b)...
-
Calculate the median for each of the following sets of data: a. 3, 4, 6, 7, 10 b. 14, 16, 19, 21, 22, 27, 36 c. 6, 6, 9, 9, 9, 10, 13, 16, 16, 21, 24 d. 4, 2, 6, 3, 8, 3, 8 e. 27, 24, 35, 30, 41, 32,...
-
Examine the following ï¬nancial statements, which are condensed versions of those of a federal agency responsible for collecting taxes and duties and transferring them to the Treasury. 1....
-
Greenwood Company manufactures two products-13,000 units of Product Y and 5,000 units of Product Z. The company uses a plantwide overhead rate based on direct labor-hours. It is considering...
-
Barrow Distributors packages and distributes industrial supplies. A standard shipment can be packaged in a Class A container, a Class K container, or a Class T container. A single Class A container...
-
Q7. What should be the transmission band width of an FM signal with 75 KHz deviation and highest frequency of modulation is 15 KHz?
-
What action/ steps can be employed to operationalize the program management practices or project portfolio management processes that are applied to navigate complexity? What challenges might be faced...
-
Recall that Article I, Section 8, clause 8 ("the Commerce Clause") grants Congress the power "to regulate commerce ... among the several states." For present purposes, "commerce ... among the several...
-
Pick up a project in your own professional area. Briefly explain what qualifies it to be a 'project'. For this project, explain what one should expect in the Project Execution Plan (PEP/PMP)....
-
Q1 Reflect upon the Indigo HR project to date. Are there any project team members or stakeholders who need to be motivated to behave differently on the project? Describe the situation and what you...
-
QUESTION THREE Bruce Smith, the director of Smith Construction Pty Ltd completed a commercial building of 12 units in Chatswood, which were built 20cm over the boundary and on completion a strata...
-
In your own construct an overview of the critical infrastructure Information Technology sector. Part 2. Examine at least three of the following: Unique aspects as they relate to national security....
-
An auto-parts manufacturer is considering establishing an engineering computing center. This center will be equipped with three engineering workstations each of which would cost $25,000 and have a...
-
Two kilograms of ice at -10° C are mixed in the insulated container of Fig. 6.50 with 12 kg of water at 25° C. Estimate the final temperature of the mixture and the net entropy change. Figure...
-
A 0.04-m3 open pan of water at 20C is sitting on the burner of a stove. How much heat is needed to completely vaporize the water?
-
Fuel and air enter the combustion chamber of Fig. 12.25 at 25 8 C, and the products exit at the same temperature. Determine the enthalpy of combustion if the fuel is a) CH4 (g), b) C3 H8 (g), c) C8...
-
A typical timber wolf has a mass of \(40 \mathrm{~kg}\), a typical jackrabbit a mass of \(2.5 \mathrm{~kg}\). Given the scaling law presented in the passage, we'd expect the specific metabolic rate...
-
A standard gold bar stored at Fort Knox, Kentucky, is 7.00 inches long, 3.63 inches wide, and 1.75 inches tall. Gold has a density of \(19,300 \mathrm{~kg} / \mathrm{m}^{3}\). What is the mass of...
-
A typical timber wolf has a mass of \(40 \mathrm{~kg}\), a typical jackrabbit a mass of \(2.5 \mathrm{~kg}\). Given the scaling law presented in the passage, we'd expect the wolf to use times more...
Study smarter with the SolutionInn App