# Question: Suppose that a quality characteristic has a normal distribution with

Suppose that a quality characteristic has a normal distribution with specification limits at USL = 100 and LSL = 90. A random sample of 30 parts results in x = 97 and s = 1.6.

(a) Calculate a point estimate of Cpk.

(b) Find a 95% confidence interval on Cpk.

(a) Calculate a point estimate of Cpk.

(b) Find a 95% confidence interval on Cpk.

**View Solution:**## Answer to relevant Questions

The molecular weight of a particular polymer should fall between 2,100 and 2,350. Fifty samples of this material were analyzed with the results x = 2,275 and s = 60. Assume that molecular weight is normally distributed. (a) ...Consider the piston ring data in Table 6.3. Estimate the process capability assuming that specifications are 74.00 ±0.035 mm. Three parts are assembled in series so that their critical dimensions x1, x2, and x3 add. The dimensions of each part are normally distributed with the following parameters: 1 100,1 4, 2 75, 2 4, ...An assembly of two parts is formed by fitting a shaft into a bearing. It is known that the inside diameters of bearings are normally distributed with mean 2.010 cm and standard deviation 0.002 cm, and that the outside ...Consider the hole diameter data in Exercise 6.9. Estimate process capability using x and R charts. If specifications are 0 ± 0.01, calculate Cp, Cpk, and Cpkm. Interpret these ratios.Post your question