Question: A 0.25-H inductor and a capacitor C are connected in series with a 60-Hz ac generator. An ac voltmeter is used to measure the rms

A 0.25-H inductor and a capacitor C are connected in series with a 60-Hz ac generator. An ac voltmeter is used to measure the rms voltages across the inductor and capacitor separately. The rms voltage across the capacitor is 75 V and that across the inductor is 50 V.

(a) Find the capacitance C and the rms current in the circuit.

(b) What would be the measured rms voltage across both the capacitor and inductor together?

Step by Step Solution

★★★★★

3.46 Rating (178 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

a I V L L I 50377 025 A ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

10-P-E-A-C (291).docx

120 KBs Word File

Students Have Also Explored These Related Electricity and Magnetism Questions!

A 15.0- resistor and a coil are connected in series with a 6.30-V battery with negligible internal resistance and a closed switch. (a) At 200 ms after the switch is opened the current has decayed to...

A 185-pF capacitor is connected in series with an unknown capacitance, and as a series combination they are connected to a battery with and emf of 25.0 V. If the 185-pF capacitor stores 125pC of...

A 175-pF capacitor is connected in series with an unknown capacitor, and as a series combination they are connected to a 25.0-V battery. If the 175-pF capacitor stores 125 pC of charge on its plates,...

Two parallel plate capacitors are lled with the same dielectric material and have the same plate area. However, the plate separation of capacitor 1 is twice that of capacitor 2. When capacitor 1 is...

Measurements 1. Using a voltmeter, set the output DC voltage of the voltage source as close to 10.0 V as you can get. Record the actual voltage. 2. Build the four capacitor circuits a, b, c, d...

Hi, I need help with completing this assignment; here is the link for it, https://phet.colorado.edu/en/simulations/circuit-construction-kit-ac PhET Simulation: This lab uses the Circuit Construction...

PhET Simulation: This lab uses the Circuit Construction Kit AC simulation from PhET Interactive Simulations at University of Colorado Boulder. After launching the simulation, please select R-L-C...

i need al the work and lab simulations and pre labs and calculations. LAB SIMULATIONS MUST BE ON PROTEUS ISIS INTRODUCTION: Linear circuit elements resistors, capacitors, and inductors are the...

I need help please. Thank you!!! PHYS 1402 Lab - 9: RLC Circuit Name: Objective . To experimentally determine the resonance frequency in a series RLC circuit and compare this to the expected...

This is a lab report given to me by Brooklyn College in my Physics 2100 class. I really need help and I would greatly appreciate it if someone may complete it to the best of their ability and answer...

A company has total sales revenue of $500,000 for the year. Sales discounts, returns, and allowances total $50,000 and the cost of goods sold is $300,000 What is the company's gross profit ratio?

question 20 Albernie LTD purchase a CCA class 8 (CCA rate of 20%) item of equipment for $90000 the equipment was the only item in the class 8 capital cost allowance pool the equipment is expected to...

On June 1 , 2 0 2 0 , a person needs $ 2 5 2 0 0 . The person will make equal monthly deposits to an account which earns 1 0 . 5 % compounded monthly. If the first deposit is made on June 1 , 2 0 1 5...

Refer to the information for Cuneo Company below. Cuneo Company's income statements for the last 3 years are as follows: Required: 1. Prepare a common-size income statement for Year 2 by expressing...

As in Example 9.1, let h (p) = p (1 p). a. Find the remainder term in the Taylor expansion, xa (x t) h (t)dt, and use it to find an exact expression for h(). b. Is the remainder term likely to be...

During 20X2, Norton Company had the following transactions: a. Cash dividends of $20,000 were paid. b. Equipment was sold for $9,600. It had an original cost of $36,000 and a book value of $18,000....

As in Example 9.1, let h (p) = p (1 p). 1. Find the remainder term in the Taylor expansion, xa (x t) h (t)dt, and use it to find an exact expression for h(). 2. Is the remainder term likely to be...

Calculate the jackknife estimate of the variance for the regression estimate of the population mean age of trees in a stand for the data in Exercise 3 of Chapter 4. How does the jack knife variance...

Which of the following describe continuous random variables? Which describe discrete random variables? a. The number of cups of coffee sold in a cafeteria during lunch b. The height of a player on a...

In Fig 12-16, if the frequency of the speakers were lowered, would the points D and C (where destructive and constructive interference occur) move farther apart or closer together?

Traditional methods of protecting the hearing of people who work in areas with very high noise levels have consisted mainly of efforts to block or reduce noise levels. With a relatively new...

Consider the two waves shown in Fig. 12-31. Each wave can be thought of as a superposition of two sound waves with slightly different frequencies of two sound waves with slightly different...

what is ABCs Corporations operating cash flow in 2020? an Wood comment ABC Corporation 2000 2015 4,000 2700 00 100 000 3.00 Cost of Goods Deprecat Carrings Before trends terem teminare 14 1.40 100 10...

For the most recent year, Seether, Inc., had sales of $444,000, cost of goods sold of $218,700, depreciation expense of $58,400, and additions to retained earnings of $50,600. The firm currently has...

John is the Project Manager for a an Application development project. The time duration for the project as agreed upon with all the Stakeholders is 12 months. The allocated budget for the project is...