Question: A certain capacitor is charged to a potential difference V. It you wish to increase its stored energy by 10%, by what percentage should you

A certain capacitor is charged to a potential difference V. It you wish to increase its stored energy by 10%, by what percentage should you increase V?

Step by Step Solution

★★★★★

3.41 Rating (160 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

We use U CV As V is increased by A... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

2-P-E-C-D (339).docx

120 KBs Word File

Students Have Also Explored These Related Electricity and Magnetism Questions!

A 2.0-F capacitor is charged to a potential difference of 12.0 V. The wires connecting the capacitor to the battery are then disconnected from the battery and connected across a second, initially...

A 100 pF capacitor is charged to a potential difference of 50 V, and the charging battery is disconnected. The capacitor is then connected in parallel with a second (initially uncharged) capacitor....

A 10.0-μF capacitor is charged to 15.0 V. It is next connected in series with an uncharged 5.00-%F capacitor. The series combination is finally connected across a 50.0-V battery, as diagrammed in...

Each shot of the laser gun most favored by Rosa the Closer, the intrepid Vigilante of the lawless 22nd century, is powered by the discharge of a 1.41 F capacitor charged to 53.5 kV. Rosa rightly...

A parallel-plate capacitor with plates of area 500 cm2 is charged to a potential difference V and is then disconnected from the voltage source. When the plates are moved 0.4 cm farther apart, the...

1. A 4.0-g bead carries a charge of 20 C. The bead is accelerated from rest through a potential difference V, and afterward, the bead is moving at 2.0 m/s. What is the magnitude of the potential...

Direction: Answer the following problems. Show your complete solution. 1. Complete the table. POTENTIAL DIFFERENCE = V= Q/C ENERGY = ENERGY STORED IN A CAPACITOR U =1cuz where C=4 = U= 1QV 2 2...

Could i get some help on this, thank you. Question 1 2' 3 1 In the gure provided , two protons are launched with the same speed from point 1 inside of a parallel-plate capacitor. If Points 2 and 3...

1. The electric potential inside a parallel-plate capacitor a. increases linearly from the negative to the positive plate. b. decreases inversely with distance from the negative plate. c. is...

Can you do the highlighter question 10,11,12? Beatriz Fernandez Lab 1? \"Charge to Mass Ratio of the electron." The electron is the rst elementary particle discovered. It was discovered by J. J....

Suppose two tidal pools are used for a tidal power plant. The upper pool, area A 1 , is filled at high tide and the lower pool, area A 2 , is emptied at low tide. The tidal range is R. (a) Determine...

The transition temperature of a BCS superconductor with an average atomic mass of 199.5 is 4.185k. what is the transition temperature for an average atomic mass of 203.4?

4. A point Q is 24 km from P and on a bearing of 072 from P. From Q, Waseem walks at a bearing of 320 to a point R, located directly north of P. Find (i) the distance between P and R, (ii) the...

Shows a mass spring system, which is constrained to move only in the horizontal direction. The specifications of the system are: the mass m = 2 kg the spring stiffness k = 1974 n/m initially the mass...

A 4kg mass connected to a k = 100N/m spring undergoes simple harmonic motion. At time t = 0, the mass is x = +10cm and moving in the negative direction at 50cm/s. (a) Find the maximum displacement...

For an LTIC system with transfer function S+5 H(s) s + 4s +3 a. Describe the differential equation relating the input x(t) and output y(t). b. Find the system response y(t) to the input x(t) =...

The equation of motion of a rotational mechanical system is derived as J, + B, + KO, = K0; where 0, and 0, denote angular displacements, and are system input and output, respec- tively. Parameters J,...

5 . find sece. 12 cot e If Question 6 Estimate the value of x in the equation: 10* 5 Question 7 If angle of elevation to the top of a building is 45 degrees. Height of the building is 20m What is the...

1. Diagram punishment by prevention a. In the Skinner box b. Bills slapping his own face 2. Argue for an analysis in terms of punishment by the prevention of the presentation of a reinforcer as...

In the Challenger Deep of the Marianas Trench, the depth of seawater is 10.9 Ion and the pressure is 1.16 X 10" Pa (about 1.15 X 10 atm). (a) If a cubic meter of waters taken from the surface to this...

A specimen of oil having an initial volume of 600 cm is subjected to a pressure increase of 3.6 X 10" Pa, and the volume is found to decrease by 0.45 cm. What is the bill: modulus of the material the...

A square steel plate is 10.0 cm on a side and 0.500 cm thick. (a) Find the sbear strain that results if a force of magnitude 9.0 X 10" N is applied to each of the four sides, parallel to the side....

Based on current dividend yields and expected capital gains, the expected rates of return on portfolios A and B are 11% and 14%, respectively. The beta of A is 0.8, while that of B is 1.5. The T-note...

Outdoor Luggage, Inc., makes high-end hard-sided luggage for sports equipment. Data concerning three of the company's most popular models appear below. Ski Guard Golf Guard Fishing Guard Selling...

Which of the following statements is CORRECT? Answer The constant growth model is often appropriate for evaluating start-up companies that do not have a stable history of growth but are expected to...