Question: A heat flux meter at the outer (cold) wall of a concrete building indicates that the heat loss through a wall of 10 cm thickness

A heat flux meter at the outer (cold) wall of a concrete building indicates that the heat loss through a wall of 10 cm thickness is 20 W/m2. If a thermocouple at the inner surface of the wall indicates a temperature of 22?C while another at the outer surface shows 6?C, calculate the thermal conductivity of the concrete and compare your result with the value in Appendix 2, Table 11.GIVENConcrete wallThickness (L) = 100 cm = 0.1 mHeat loss (q/A) = 20 W/m2Surface temperatureInner (Ti) = 22?COuter (To) = 6?CASSUMPTIONSOne dimensional heat flow through the wallSteady state conditionsexist

- L-0.1 m - T= 22C

Step by Step Solution

★★★★★

3.35 Rating (167 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

The rate of heat transfer for steady state one dimensional ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

66-E-M-E-H-M-T (1414).docx

120 KBs Word File

Students Have Also Explored These Related Mechanical Engineering Questions!

The outer surface of a 0.2m-thick concrete wall is kept at a temperature of ??5?C, while the inner surface is kept at 20?C. The thermal conductivity of the concrete is 1.2 W/(m K). Determine the heat...

A plane wall 15 cm thick has a thermal conductivity given by the relationk = 2.0 + 0.0005 T W/(m K)where T is in degrees Kelvin. If one surface of this wall is maintained at 150 ?C and the other at...

A 0.5-m-diametcr concrete pipe (5.0 cm wall thickness with rigid pipe walls) carries water 600 m before discharging it into another reservoir. The surface elevation of the downstream reservoir is 55...

Consider a 1-D steady state heat conduction in a composite wall made up of two different materials A (k= 45 W/m K) and B (k = 28 W/m K). There is a heating element passing through the material A...

Problem #4:Consider a long solid cylinder of radius ro = 4 cm and thermal conductivity k = 25 W/m C. Heat is generated in the cylinder uniformly at a rate of go = 35 W/cm3. The side surface of the...

A thin electrical heating element provides a uniform heat flux q;' to the outer surface of a duct through which air flows. The duct wall has a thickness of 10 mm and a thermal conductivity of 20 W/m...

show all steps Q1: Consider the heat flow in one direction (x-axis) through the composite wall shown in Figure Q1. Draw the thermal circuit then determine TI and T2, and the heat flux (q, W/m),...

Question 1 A furnace wall consisting of 0.20 m of fire clay brick, 0.15 m of kaolin, and a 0.05-m outer layer of masonry brick is exposed to furnace gas at 1250 K with air at 298 K adjacent to the...

o The inner surface of a furnace wall is exposed to hot flue gases at T,i = 500 C with the corresponding convective heat transfer coefficient hi = 100 W/m2 K. The wall is 10 cm thick and has thermal...

Repeat Prob. 573 by disregarding radiation heat transfer from the outer surfaces of the chimney. Data from problem 73 Hot combustion gases of a furnace are flowing through a concrete chimney (k = 1.4...

Using a five-prong test the court found three factors that pointed to one conclusion and two to the other Is a simple three to two majority sufficient to make a decision here?

Build a case against forgiveness of external debt of developing countries.

Current Attempt in Progress It is now May 1 , 2 0 2 2 , and Kenneth has just purchased a five - year U . S . government bond ( \ ( \ mathrm { FV } = \ $ 1 , 0 0 0 \ ) ) with a quoted price of 9 3 . 9...

Yankee Corporation has suffered a large net operating loss. Which sources of income should be considered when estimating the future realization of a tax benefit from this loss? Briefly describe each....

Donovan Corp., a calendar-year-end company, operates a profitable division in Jurisdiction A. In January 2014, Jurisdiction A enacted a tax law that changed the tax rate structure from 30 percent to...

If Newton Manufacturers has an accounts receivable turnover of 4.8 times and net sales of $7,812,379, what is its receivables?

Accountants at the Tucson firm, Larry Youdelman, CPAs, believed that several traveling executives were submitting unusually high travel vouchers when they returned from business trips. First, they...

Upstate Mechanical, Inc. has been producing two bearings, components T79 and B81, for use in production. Data regarding these two components follow. Variable manufacturing overhead is applied on the...

Which organelles are in the endomembrane system?

In the spring, concrete surfaces such as sidewalks and driveways are sometimes very wet in the morning, even when it has not rained during the night. Typical night-time conditions are shown in the...

Dry air at 32C flows over a wetted (water) plate of 0.2 m2 area. The average convection coefficient is h = 20 W/m2 K, and the heater power required to maintain the plate at a temperature of 27C is...

Dry air at 32C flows over a wetted plate of length 200 mm and width 1 m (case A). An imbedded electrical heater supplies 432 Wand the surface temperature is 27C. (a) What is the evaporation rate of...

The payback method helps firms establish and identify a maximum acceptable payback period that helps in capital budgeting decisions. There are two versions of the payback method: the conventional...

Suppose your company needs to raise $41 million and you want to issue 20-year bonds for this purpose. Assume the required return on your bond issue will be 8 percent, and youre evaluating two issue...

2. Write the Hexadecimal machine code for xori $s4,$t0,14 and show all the steps of how you reached the answer. (1 point)