Question: A highly oxidized and uneven round bar is being turned on a lathe. Would you recommend a relatively small or large depth of cut? Explain
A highly oxidized and uneven round bar is being turned on a lathe. Would you recommend a relatively small or large depth of cut? Explain your reasons.
Step by Step Solution
3.30 Rating (174 Votes )
There are 3 Steps involved in it
Oxides are generally hard and abrasive So light cuts will cause the tool to wear ... View full answer
Get step-by-step solutions from verified subject matter experts
Document Format (1 attachment)
972-E-M-E-B-D (731).docx
120 KBs Word File
