Question: How does the thermal efficiency of an ideal cycle, in general, compare to that of a Carnot cycle operating between the same temperature limits?

How does the thermal efficiency of an ideal cycle, in general, compare to that of a Carnot cycle operating between the same temperature limits?

Step by Step Solution

★★★★★

3.49 Rating (186 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

It is less ... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Document Format (1 attachment)

Word file Icon

E-ME-T (2300).docx

120 KBs Word File

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

How does the thermal efficiency of an ideal Otto cycle change with the compression ratio of the engine and the specific heat ratio of the working fluid?

Q:

How does the thermal efficiency of the cycle in Prob. 13-61E compare to that predicted by air standard analysis? Prob. 13-61E The gas passing through the turbine of a simple ideal Brayton cycle has...

Q:

Develop an expression for the thermal efficiency of an ideal Brayton cycle with an ideal regenerator of effectiveness 100 percent. Use constant specific heats at room temperature.

Q:

Consider an ideal Rankine cycle using steam as the working fluid. The condenser pressure is 0.1 bar. The boiler pressure is 20 bar. The steam leaves the boiler as a saturated vapor. If we consider...

Q:

2 . A thermal power plant based on an ideal reheat cycle uses steam as the operating fluid and is operated between 8 0 0 psi and 2 psi. The pressure and temperature at the turbine inlet are 8 0 0...

Q:

The condenser pressure of the turbine in P3.2 is reduced to 0.15 bar. Calculate the same parameters for this cycle as in the previous example. Why have the parameters improved so much? [28.97\%;...

Q:

A steam power plant operating on a basic Rankine cycle has the following parameters: maximum (boiler) pressure 20 bar; minimum (condenser) pressure 0.5 bar. Calculate the thermal efficiency of the...

Q:

HW# 7 - 1 ( 1 5 pt ) Consider a Carnot cycle executed in a closed system with air as the working fluid. The minimum pressure ( P ) in the cycle is 1 0 0 kPa while the minimum temperature ( T ) is 3 0...

Q:

Consider a Carnot cycle executed in a closed system with air as the working fluid. The maximum pressure in the cycle is 800 kPa while the maximum temperature is 750 K. If the entropy increase during...

Q:

Consider a Carnot cycle executed in a closed system with air as the working fluid. The maximum pressure in the cycle is 1300 kPa while the maximum temperature is 950 K. If the entropy increase during...

Q:

The Sale of Goods Act imposes terms relating to goods matching samples or descriptions, and meeting standards of fitness, quality and title. Explain the nature of these implied terms and their effect...

Q:

20. A small car rental agency can rent every one of its 62 cars for $25 per day. For each $1 increase in daily rate, two fewer cars are rented. a) Find a quadratic function that describes all...

Q:

Question 3 - Test 1 - Connect Help Sove 8 Exit SWbmit re self - fulfilling prophecy process occurs when a supervisor's general impression of a person distorts their perception of other...

Q:

Assume that the port 47H drives the traffic light signals. port 47H Steps Time P4 P3 P2 P1 PO Green Yellow Red Walk Don't Walk 57 sec ON OFF OFF ON OFF 10 sec OFF ON OFF OFF ON 3 34 sec OFF OFF ON...

Q:

Answer the point-form questions (but don't forget the important details !): 1. During their childhood, the narrator and his friends lived in three places: the school, the church, and ( The most...

Q:

Draw a stepwise mechanism for the conversion of hex-5-en-1-ol to the cyclic ether A. hex-5-en-1-ol OH HSO4 A

Q:

http://www.digitaljournal.com/ pr/4690725 I need your own thoughts on the topic from this website! Thanks

Q:

Dalol Company, which began operations on January 2, Year 4, appropriately uses the installment method of accounting. The following information is available for the year ended December 31, Year 4....

Q:

Is it fair for creditors to continue reporting late payments after the payments have been made? What do you think about experts suggestion that people with credit blemishes write a sincere goodwill...

Q:

Butler Manufacturing manufactures two products, (1) Regular and (2) Deluxe. The budgeted units to be produced are as follows: Units of Product 2016 July August September October Deluxe 15,000 10,000...

Q:

Question 7 Not yet answered Marked out of 10.00 P Flag question 2. Discuss The difference between management and administration" in detail and in your own words

Q:

Periodic Inventory by Three Methods Dymac Appliances uses the periodic inventory system. Details regarding the inventory of appliances at January 1, purchases invoices during the next 12 months, and...