Question: If a right-angle bend is to be made in a cold-rolled sheet, should it be made with the bend lying along or perpendicular to the

If a right-angle bend is to be made in a cold-rolled sheet, should it be made with the bend lying along or perpendicular to the direction of previous rolling?

Step by Step Solution

★★★★★

3.46 Rating (169 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

To conclude I can say that whenever possible th... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

916-E-M-S-E-M-S (1471).docx

120 KBs Word File

Students Have Also Explored These Related Materials Science Engineering Questions!

A very long straight wire carries current I. In the middle of the wire a right-angle bend is made. The bend forms an arc of a circle of radius r, as shown in Figure P30.10. Determine the magnetic...

Consider a long wire that makes a right angle (90) bend as shown in Figure P20.71. If the wire carries a current I, what is the magnetic field at point A? Use the result for the field from an...

The member is to be made from a steel plate that is 0.25 in. thick. If a 1-in. hole is drilled through its center, determine the approximate width w of the plate so that it can support an axial force...

4.3-1. Momentum Balance in a Reducing Bend. Water is flowing at steady state through the reducing bend in Fig. 4.3-3. The angle Q2 90 (a right-angle bend). The pressure at point 2 is 1.0 atm abs. The...

NEAT HANDWRITTEN ,DON'T COPY . Water at a pressure of 350 kPa flows through a right-angle bend of 25 cm diameter at a rate of 246 liters per second. The bend lies in a horizontal plane. Assuming...

Question 5 . Water under a gage pressure of 3 5 0 kPa flows with a velocity of 5 m s through a right - angle bend that has a uniform diameter of 2 5 0 mm . The bend lies in a horizontal plane and...

Question 4 10 pts A conductor in the shape of a square loop of edge length (() carries a current () as shown in the Figure. Given /=25.0cm, and I=3.41A. Calculate the magnitude of the magnetic field...

A reducing right - angle bend lies in a horizontal plane. Water enters from the west ( Section 1 ) with a velocity of 4 . 1 m s and a pressure of 3 2 . 7 kPa, and it leaves toward the north ( Section...

Member ABC in the figure has a circular cross section with radius r. It has a right-angle bend at B and is loaded by a load P perpendicular to the plane of ABC. Determine the component of deflection...

A wire with conductivity carries a steady current I. Confirm the statement made in the text that a charge Q = 0 I/ accumulates on the wires surface in the immediate neighborhood of a 90...

In 2014, National Utility issued $60,000,000 of 10%, 25-year bonds at par. The current market rate on bonds with the same rating is 8%. The bond contract will allow refunding of these bonds in 2019....

A mass 'm' moving with velocity 40 m/s suddenly breaks into two masses of ratio 1: 2. The smaller block has velocity 60 m/s in same direction. Find percentage loss in kinetic energy of system : (1)...

What were the major differences between scientific management, as taught by Frederick Taylor, and that espoused by the Gilbreths?

Hugging in the workplace is still frequent, but why is it that you are unlikely to be hugged by (a) a sales associate in a retail store, (b) your medical care provider, or (c) the mechanic who...

Find Io in the circuit in Figure 8.14 4 3Q i2 13 2420W Io 2 Figure P8. 14

Write the mesh equations for the network in Figure P8.15 Ri j6d 0L2 I, joLi joM Figure P8. 15

Write the mesh equations for the network shown in Figure P8.16 R1 Ww 2 R2 1 joL jcoL2 joM

5 pts Question 18 Use the following table to calculate the variance and the return for stock given the probability and returns noted below. Report your answer in a decimal equivalent value (6% should...

You are considering two independent projects with the same discount rate of 11 percent. Project A costs $284,700 and has cash flows of $75,900, $106,400, and $159,800 for Years 1 to 3, respectively....

In order for you to be indifferent between the after tax returns on a corporate bond paying 6% and a tax-exempt bond paying 4.32%, what would you tax bracket need to be? a) 35% b) 32% c) 28% d) 22%