Question: In an engine a mixture of liquid octane and ethanol, mole ratio 9;1, and stoichiometric air are taken in at T0, P0. In the engine

In an engine a mixture of liquid octane and ethanol, mole ratio 9;1, and stoichiometric air are taken in at T0, P0. In the engine the enthalpy of combustion is used so that 30% goes out as work, 30% goes out as heat loss and the rest goes out the exhaust. Find the work and heat transfer per kilogram of fuel mixture and also the exhaust temperature.

Step by Step Solution

★★★★★

3.36 Rating (165 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

09 CH8 01 CHOH 1155 O 43428 N For 09 octane 01 ethanol Energy in 0 ex HRP M 09 ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

E-ME-T (3864).docx

120 KBs Word File

Students Have Also Explored These Related Mechanical Engineering Questions!

A rigid 10-L vessel initially contains a mixture of liquid water and vapor at 100oC with 12.3 percent quality. The mixture is then heated until its temperature is 150oC. Calculate the heat transfer...

A propane tank is filled with a mixture of liquid and vapor propane. Can the contents of this tank be considered a pure substance? Explain.

Liquid octane enters an internal combustion engine operating at steady state with a mass flow rate of 0.0018 kg/s and is mixed with the theoretical amount of air. The fuel and air enter the engine at...

In a four-stroke Otto engine, a mixture of fuel and air is injected in a cylinder with volume V3 (using the notation of Fig. 6-right the lecture notes). The mixture is then compressed by a piston...

Can you please write the requirements for combustion and a conclusion for combustion report, as soon as possible please!! Combustion Table of contents Introduction combustion is a chemical reaction...

Thermodynamics is a branch of chemistry and physics that deals with energy. The basic function of the engine is to convert chemical energy (stored in the atomic bonds of the gasoline) to rotational...

A mixture of 75% carbon dioxide and 25% water by mass is flowing at 1600 K, 100 kPa into a heat exchanger where it is used to deliver energy to a heat engine. The mixture leave the heat exchanger at...

A mixture of 75% carbon dioxide and 25% water on a mole basis is flowing at 1600 K, 100 kPa into a heat exchanger, where it is used to deliver energy to a heat engine. The mixture have leave the heat...

can some one show me how to set this up and solve it ive tried 3 different ways A forester mixes gasoline and oil to make 2 gallons of mixture for a two-cycle chainsaw engine. This mixture is 32...

g=0.6 h=400. k=-1.415 6) Integrate a) f(5t3 + g)dt b) f0! e'm" + 4 cos(2x))dx 7) The area under the force-displacement (Rx) graph of a spring under compression represents the work done in compressing...

Darrell Keith is starting a new business. He plans to keep a tight control over it. Therefore, he wants to know exactly how much gross profit he earns on each unit that he sells. Darrell sets up an...

Domingo-Salvany et al. (1995) also used capturerecapture on the emergency room survey by dividing the list into four samples according to trimester (TR).The following data are from Table 1 of their...

(Section 8.1) Why is world trade rising faster than world output? Why is so much trade in manufactured goods?

A typical cross-section of a reinforced concrete beam is shown in the figure that follows. The concrete and steel material properties are given below. Use an effective depth of 650 mm. a) Determine...

Keebee, Inc. produces desktop and laptop computers. The company currently uses traditional volume-based cost system and applies manufacturing overhead cost to products on the basis of direct labor...

The Following Items/Events Relate To Hospitals Covered By The AICPA Audit Guide On Health Care Providers And FAS #116, #117, #124, And #136. Each Choice May Be Used More Than Once. Classify Each Of...

Frank Thompson operates a small business that manufactures oversized backyard games. He runs the business as a sole proprietorship. The company uses a job order cost system using a first-in,...

12.7 Trading Places: Two players, 1 and 2, each own a house. Each player i values his own house at v. The value of player i's house to the other player, i.e., to player ji, is v. Each player i knows...

Use Lagrange multipliers to find the maximum and minimum values of the function subject to the given constraint(s). f(x, y) = e xy ; x 3 + y 3 = 16

C++ Program Fix the errors II main.cpp les 118 SelectionSort (arr, n): 119 break: 120 121 case 3:( 122 123 cout:: const iterator ptr-numerical_comparisions.begin (): ptr!-numerical_comparisions.end...

Define the expected rate of return to bondholders.

The Ajax Corporation has an overhead crane that has an estimated remaining life of 10 years. The crane can be sold now for $8,000. If the crane is kept in service, it must be overhauled immediately...