Question: Explain the differences between the concentration units molarity and mole fraction. Can molarity be used to describe the concentration of a mixture of gases?

Explain the differences between the concentration unit’s molarity and mole fraction. Can molarity be used to describe the concentration of a mixture of gases?

Step by Step Solution

★★★★★

3.38 Rating (167 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Molarity for Gases Molarity is not wellsuited for describing the concentratio... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemistry Principles And Practice Questions!

Planning is one of the most important management functions in any business. A front office managers first step in planning should involve determine the departments goals. Planning also includes...

A mixture of gases A and B is contained in a constant-volume vessel at a temperature of 400 K and a pressure of 1 bar. The ideal gas law can be used to describe the behavior of each gas in the...

Explain the differences between x-bar and R-charts. How can they be used together and why would it be important to use them together?

Be sure your stirring rod is washed and dried. Stir well. This is your starting citric acid solution. You will need to calculate the molarity of this citric acid solution and use that to standardize...

Problem 1: For the HDA process, generate a detailed P&ID for the fired heater (H-101) based on the lecture notes of HAZOP study and analysis. Problem 2: For the attached acrylic acid process, answer...

Data table 1: For each trial, the contents listed for each flask were placed into their respective flask. Each flask was then placed into a 21.5 degrees celsius water bath, then Flask B was poured...

Question B ( 2 5 Marks ) When sitting and doing light desk work, a 2 0 - year - old student exhales C O 2 at an average rate of approximately 2 1 0 - 4 m o l s . Suppose there are several students in...

plz calc and explain B C D Calculate the mass percent of KCl in the solution. Express your answer with the appropriate units. View Available Hint(s) 11.4% Previous Answers Correct Calculate the mole...

effective status reports used in project management. b) Discuss challenges and pitfalls for each of the projectstatus reports. c) Explain the difference between the projectstatusreports provided for...

Following are some of the tests of controls and substantive tests of transactions procedures often performed in the payroll and personnel cycle. (Each procedure is to be done on a sample basis.) 1....

A piece of equipment cost $100,000 to purchase and $60,000 to install seven years ago. The market value now is $33,000, and this will decline by 12 percent of the current value each year for the next...

If Linear were to pay out its entire cash balance as a special dividend, what would be the effect on value? On the share price? On earnings? On earnings per share? What if Linear repurchased shares...

12. Rory Company manufactures goods in Division A that are transferred to Division B for use in its products. Division As costs are $25 per unit, plus $10,000,000 in fixed costs. Division Bs costs...

There are more electrons in the n = 4 shell than for the n = 3 shell in krypton. However, the peak in the radial distribution in Figure 21.6 is smaller for the n = 4 shell than for the n = 3 shell....

How is the effective nuclear charge related to the size of the basis set in a Hartree Fock calculation?

Using the result of Problem P20.12, calculate the probability of finding the electron in the 1s state outside a sphere of radius 0.75a 0 , 2.5a 0 , and 4.5a 0 .

Mutual fund managers use two primary types of research: fundamental and quantitative Select one: True False

USAR and USALI: Select one: a. Do not fit all sizes of hospitality operations b. Are applicable to any industry c. Do not recommend ASPE financial statements d. Reflect the hospitality industrys...

Empty elements have an end tag.Select one:TrueFalse