Question: Using nine bits, how close to 326 rpm can the motor speed be adjusted?

Using nine bits, how close to 326 rpm can the motor speed be adjusted?

Step by Step Solution

★★★★★

3.26 Rating (149 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

With nine bits there will be 511 steps 2 9 1 Thus the motor speed will go up in steps of 1... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Digital Systems Principles And Application Questions!

Q:

For this essay, you will select ONLY ONE of the following data sets. Music and Mental Health Survey Data: For this case, you will write as though you have been hired by the research team that...

Q:

Assuming a 12-bit DAC with perfect accuracy, how close to 250 rpm can the motor speed be adjusted in Figure 11-4? Figure 11-4 Computer DAC lOUT 0-2 mA Current amp. Motor 01000 rpm

Q:

Figure 11-4 shows a computer controlling the speed of a motor. The 0- to 2-mA analog current from the DAC is amplified to produce motor speeds from 0 to 1000 rpm (revolutions per minute). How many...

Q:

For the system of Figure 11-4, how many bits should be used if the computer is to control the motor speed within 0.4 rpm? Figure 11-14 lOUT Current Bitty DAC 0-2 MA amp. Computer Motor 0-1000 rpm

Q:

Page Page number of 1 Hydrostatic Design 1 ROBO 3 5 1 Calculate for the required hydrostatic transmission to drive a four wheel drive skid steer vehicle powered by 2 fixed displacement motors that...

Q:

CECS 346 Project 3 A Smart Home By Dr. Min He Preparation: You will need two LaunchPads, 3 stepper motors with drivers (can be checked out from the instructor), 2 obstacle avoidance sensors (can be...

Q:

Paraphrase the situations in Toyota, Nissan and Honda. From Case Studies at Toyota, Nissan and Honda! 286 M. Sake 3. Case Studies at Toyota, Nissan and Honda 3.1 Toyota Toyota is noted for two things...

Q:

Develop a C-language code for PIC18F4550 to control the position (speed and direction) of a DC Motor based on the feedback from a potentiometric sensor connected to the shaft of the motor. When the...

Q:

A centrifugal pump is capable of delivering 50 L/s of fluid at a head of 18 m while operating at 3550 rpm with a 7-inch impeller. At this condition, the pump power draw is 12 kW and the pump...

Q:

Create charts to better understand data sets. For cross-sectional data, use a scatter chart. For time series data, use a line chart. Linear y = a + bx Logarithmic y = ln(x) Polynomial (2nd order) y =...

Q:

What is "profiling"? What are the advantages and disadvantages of its use? How does the use of profiling relate to ethics? 20) A moral and ethical issue raised by the information age is the...

Q:

5. What is the magnitude of the current in the 20-2 resistor? (Ans: 0.5 A) 10 V 111+ I 10 22 20 2 15 V Lumt 10 (2 6. Determine the magnitude and sense (direction) of the current in the 500-52...

Q:

1 John Smith, the research manager for marketing at the Chevrolet Division of the General Motors Corporation, has specified the following general demand function for Chevrolets in the United...

Q:

QUESTION 1 7 . ( 1 5 marks in total ) a ) The following financial data is available for firm TEZLA for the year 2 0 1 9 . Balance sheet: Average inventory: USD 7 5 0 0 0 0 . Average accounts...

Q:

explore some simple mechanisms for strategy formation leading to the formulation of strategic options that relate to configurations of organizations determined by their maturity and dynamics of their...

Q:

An unhappy 0.300-kg rodent, moving on the end of a spring with force constant k = 2.50 N/m, is acted on by a damping force Fx = -bv x. (a) If the constant b has the value 0.900 kg/s, what is the...

Q:

A 50.0-g hard-boiled egg moves on the end of a spring with force constant k = 25.0 N/m. Its initial displacement is 0.300 m. A damping force Fx = -bv x acts on the egg, and the amplitude of the...

Q:

A sinusoidally varying driving force is applied to a damped harmonic oscillator of force constant k and mass m. If the damping constant has a value bl> the amplitude is A, when the driving angular...

Q:

At the beginning of the year, a firm has current assets of $332 and current liabilities of $236. At the end of the year, the current assets are $501 and the current liabilities are $276. What is the...

Q:

identify the size of the parameters Z and A Matrices for hidden layers and output layers

Q:

Over the period from 1926 through 2020, the annual rate of return on _____ was more volatile than the annual rate of return on _____. Multiple Choice large-company stocks; small-company stocks U.S....