Question: Which will cause a smaller decrease in output voltage for a given voltage divider, a 10 k load or a 56 k load?

Which will cause a smaller decrease in output voltage for a given voltage divider, a 10 kΩ load or a 56 kΩ load?

Step by Step Solution

★★★★★

3.41 Rating (145 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

In a voltage divider circuit the output voltage is determined by the ratio of the resis... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electronics Fundamentals A Systems Approach Questions!

Q:

Managing Scope Changes Case Study Scope changes on a project can occur regardless of how well the project is planned or executed. Scope changes can be the result of something that was omitted during...

Q:

Represent tbe decimal number 6248 in the following codes a) BCD b)Excess-3 c)6-3-1-1 weighted code d) 2-4-2-1 weigtged code

Q:

A power supply has a fixed output voltage of 12.0 V, but you need VT = 3.0V for an experiment. (a) Using the voltage divider shown in Fig. 19-66, what should R2 be if R1 is 10.0? (b) What will the...

Q:

A servo motor (or "servo") is a continuous DC motor packaged together with reduction gears, a potentiometer to measure rotation, and electronics connecting the potentiometer output to the motor drive...

Q:

In TASK 7, you should have noticed that the voltage drop across each of the different resistances is different; this is expected, because the voltage across each resistor is given by Ohm's Law, V =...

Q:

Scenario You and your group work for a multi-national consulting firm. Your team is a group of capital budget consultants and are seeking new engagements. You intend on responding to a Request for...

Q:

Critically and thoroughly analyse the circuit. Provide a thorough analysis with equations and diagrams. conclude based on the analysis whether you would recommend the circuit or not. The 32VRMs...

Q:

Using Savings Matrix Method and distance using Google Maps solve the following Niazi Express Cargo service has been operating since the inception of Daewoo Express in Pakistan. Its Cargo Setups,...

Q:

Using Savings Matrix Method and distance using Google Maps solve the following Niazi Express Cargo service has been operating since the inception of Daewoo Express in Pakistan. Its Cargo Setups,...

Q:

my id is ep0105404 so last digit would be 4 A three-phase uncontrolled rectifier is commonly employed to first converting ac power into de power in most of the motor drives applications. Figure 1...

Q:

Suppose that a monopolist is considering entering a new market. The market demand for the product is given by the following function: Q = 500 - 5P, where Q is the quantity of the product demanded and...

Q:

+=t+31t-2e' The solution of the differential equation y"-10y'+9y=5t, y(0) =-1 y'(0)=2is 50 5 50 5 () 31 (A) +-t+ | 81 81 9+e" -2e' 81 9 81 5. 31 2e e-2e' 81 50 5 31 9t 2e (C) 81 9 (D) +-t %3D 81 9 81

Q:

Acctg 3 2 2 Assignment, Winter of 2 0 2 5 Requirement: Complete the various budget schedules below using Excel. Each student must upload their completed schedules in the Excel Mekanas link. Separate...

Q:

Consider the graph given in exercise

Q:

When fluid flows over a surface, the Reynolds number will output whether the flow is laminar (smooth), transitional, or turbulent. Verify that the Reynolds number is dimensionless using the SI. The...

Q:

Determine which one of the following equations is dimensionally consistent. where F is force, m is mass, x is distance, V is velocity, and t is time. F = }mar FAV = mAx FAx AV FAt = AV FAV= 2mA? %3|...

Q:

Referring to Problem P3.23 and Table 3.5, if the units for c p and are Btu/(slug F) and slug/(ft h), respectively, what must be the USCS units of thermal conductivity in the definition of Pr?...

Q:

Preble Company manufactures one product. Its variable manufacturing overhead is applied to production based on direct labor-hours and its standard cost card per unit is as follows: Direct materials:...

Q:

The following information concerns production in the Forging Department for November. All direct materials are placed into the process at the beginning of production, and conversion costs are...

Q:

Luis Herrera, an up-and-coming fashion designer, created a new line of mens fashion socks in response to the growing number of celebrities who are expressing their individuality by replacing...