Question: For a particular casting process the constant K in Chvorinovs equation in Exercise 2 is 3.00 s/mm 2 for a cylindrical casting 150.mmhigh and 100.mmin

For a particular casting process the constant K in Chvorinov’s equation in Exercise 2 is 3.00 s/mm² for a cylindrical casting 150.mmhigh and 100.mmin diameter. Determine the solidification time for this casting.

Exercise 2

Solidification time = K × (Volume = Surface area)²

Step by Step Solution

★★★★★

3.46 Rating (156 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Chvorinovs equation is used to calculate the solidification time of a casting and it is given by Sol... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Exploring Engineering Introduction Questions!

A casting process involves pouring molten metal into a mold, letting the metal cool and solidify, and removing the part from the mold. The solidification time is a function of the casting volume and...

Demonstrate that the constant K in Equation 17.23 will have values of 534 and 87.6 for the CPR in units of mpy and mm/yr,respectively. KW pAt CPR (17.23)

Demonstrate that the constant K in Equation 17.23 will have values of 534 and 87.6 for the CPR in units of mpy and mm/yr, respectively.

B. In metal casting process, solidification time is a function of the volume of a casting and its surface area as expressed by Chrovinov's rule [TTS =Cm(V/A)2 ]. This equation can also be used in...

Hello, you already did chapter 1 and 2 of my MASTERS Thesis already for me. (See attached) So normally you know masters thesis consist of 5 chapters right ??..... But in this case my thesis will be 4...

CASE 16 Nucor Corporation in 2014: Combating Low-Cost Foreign Imports and Depressed Market Demand for Steel Products Arthur A. Thompson The University of Alabama n 2014, Nucor Corporation, with a...

ructure.com/counts/3444/igments/1474195 Mindset:Acknowledge the relationship between costs and financial performance Instructions The value of the Case Study is to identify and explain in detail the...

Evaluate the generic competitive strategies pursued by Nucor and key industry competitors. Provide recommendations for Nucor Use this format for case analyses in strategic management....

*** Excel sheet required only for 3 parts using the following data. Urgently *** For this assignment, you are going to use a MS Excel spreadsheet to simulate a series of sequential processes in an...

Name at least three administrative agencies at each level of government: federal, state, and local.

Draw the payoff for a portfolio of a share of venture equity and a short (sold) call option to buy that share at $5.

2. What is the matching principle and what role does it play in the financial reporting process?

=+ Evaluating the present

Two line loads q 1 and q 2 of infinite lengths are acting on top of an elastic medium, as shown in Figure P8.6. Find the vertical stress increase at A. Figure P8.6. 30 kN/m 92 = 40 kN/m %3D 6 m + 3 m...

A 3 m wide and infinitely long flexible strip load of 40 kN/m 2 is placed on an elastic medium as shown in Figure P8.7. Find the vertical stress increase at points A, B, and C located 1 m below the...

Figure P8.8 shows a flexible rectangular raft that is 8 m 16 m and applies a uniform pressure of 80 kN/m 2 to the underlying ground. Find the vertical stress increase at 4 m below A, B, C, and D....

You are trying to pick the least-expensive car for your new delivery service. You have two choices: the Scion xA, which will cost $23,500 to purchase and which will have OCF of $3,100 annually...

Consider the following spot interest rates for maturities of one, two, three, and four years. r1 = 6.5% r2 = 7.0% 13 = 7.7% r4 = 8.5% Assuming a constant real interest rate of 2 percent, what are the...

Periodic interest rates. In the following table, fill in the periodic rates and the effective annual rates. First, fill in the periodic rates in the following table. (Round to two decimal places.)...