1) A system is loaded as shown in the figure below. Points A and C are bearing locations. Shaft is made of a steel having Sy: 5AB MPa and Sut: 6BA MPa. (All dimensions are in mm, D/d is 1.1 and fillet radius are 3 mm.) a) Evaluate the total forces, moments and torques acting onto the system. b) Design the shaft based on a factor of safety of A,B for 90 percent reliability and infinite life. The shaft is machined surface. (In the question A and B is the last two digits of your student number, respectively. If A and/or B is equal to zero assume them 1.) Mil ve bileenleri ekildeki gibi yklenmitir. A ve C noktalarndan yataklama yaplmtr. Mil elik malzemeden yaplm olup Sy: 5AB MPa and Sut: 6BA MPa'dr (Btn ller mm cinsinden verilmitir, D/d 1.1 ve yuvarlatma aplar 3 mm'dir). a) Sisteme etkiyen tm kuvvet, moment ve torklar belirleyiniz. b) A,B emniyet katsays, %90 gvenilirlik ve sonsuz mr koullarnda mil tasarmn gerekletiriniz. Mil yzeyi talal ilenmitir. (Soruda verilen A ve B srasyla renci numarasnn son iki hanesidir. Eer A ve/veya B sfra eitse ilgili deerleri 1 olarak kabul ediniz.) Z 2AB y A 0120 B B 2AB 350N 1AB 600N 400N E 250N 0160 NOTE! State all the assumptions that you make in design process in the assignment. NOT! Tasarm prosesinde gerekli grdnz tm kabulleri projede belirtiniz.