Question: 1) A system is loaded as shown in the figure below. Points A and C are bearing locations. Shaft is made of a steel
1) A system is loaded as shown in the figure below. Points A and C are bearing locations. Shaft is made of a steel having Sy: 5AB MPa and Sut: 6BA MPa. (All dimensions are in mm, D/d is 1.1 and fillet radius are 3 mm.) a) Evaluate the total forces, moments and torques acting onto the system. b) Design the shaft based on a factor of safety of A,B for 90 percent reliability and infinite life. The shaft is machined surface. (In the question A and B is the last two digits of your student number, respectively. If A and/or B is equal to zero assume them 1.) A 2AB y 120 B 600N 2AB 400N 1AB E 160 350N 250N NOTE ! State all the assumptions that you make in design process in the assignment. NOT! Tasarm prosesinde gerekli grdnz tm kabulleri projede belirtiniz.
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
