Question: 1. Set to Oscillate and No End 2. Keep the ruler and timer on. 3. Set the frequency to 1 and tension to low. 4.

1. Set to "Oscillate" and "No End" 2. Keep the ruler and timer on. 3. Set the frequency to 1 and tension to low. 4. Measure the time it takes for a wave to travel the length of the string. 5. Measure the length of a single wavelength. 6. Do the same measurements at Frequency = 2 and 3 Hz. 7. Repeat the experiment at moderate and high tension Results: Tension Frequency Time to travel Wavelength Speed = Frequency X the length of Length/time wavelength the string Low 1 Low 2 5-5 MALAYAN COLLEGES LAGUNA
Step by Step Solution
There are 3 Steps involved in it
1 Expert Approved Answer
Step: 1 Unlock
Question Has Been Solved by an Expert!
Get step-by-step solutions from verified subject matter experts
Step: 2 Unlock
Step: 3 Unlock
