10. Develop a C# Windows form application for calculating feed and speed rates for a CNC end mill tool. The form should look like the following figure. The green boxes below the button are LABELS and are outputs; the TEXTBOX fields above the button are inputs. Clicking the button should perform the calculation and write the results for the three output labels. End Mill Feed & Speed Calculator - Cutter Diameter (nches) 0.125 MI Material: Magnesium Feed per Tooth tooth): 0.002 Number of teeth Calculate Feed & Speed Tool Speed (sfm): Spindle Speed (rpm): Feed Rate fpm): 300 9167. 366.7 The values shown in the textboxes and green labels are examples inputs and outputs and should serve as a test case. For reference in testing, feed per tooth (ft/tooth) is typically in the range of 0.002 to 0.010 ft/tooth. Tool speed, given in surface feet per minute (sfm), is based on the material chosen, and is defined by the following table (which also defines the materials to list in your mill material combobox): 150 Milling Speeds (HSS End Mills) Material Average Tool Speed (S.F.M) Magnesium 300 Aluminum, 7075 300 Aluminum, 6061 280 Aluminum, 2024 200 Aluminum, Cast 134 Brass 400 Bronze Copper Cast Iron (soft) Cast Iron (hard) Mild Steel Cast Steel Alloy Steels (hard) Tool Steel Stainless Steel Titanium Hiah Manganese Steel Spindle speed, in revolutions per minute (rpm), is calculated by the equation: Spindle Speed = (12.0 * Tool Speed)/(PI * Cutter Diameter) Feed Rate, in feet per minute (fpm), is calculated by the equation: Feed Rate = Feed Per Tooth x Number of Teeth x Spindle Speed