11 C Lab 10 AC | RC theory httpszllyoutube/rGFeENMRvgg 11 C Lab 10 AC i RC high-pass lter experiment httpsz/lyoutu.be/PrsHSlmeUw Experiment. An RC circuit was assembled according to the circuit diagram shown in Fig. 10.1 of the lab manual. A function generator generating a sinusoidal waive of variable frequency served as an AC. source. A resistor with the measured resistance of 100.6 Ohms was connected in series with a capacitor with the capacitance of C= 0.962 pF. A sinusoidal signal applied to the circuit was registered on Chl of the oscilloscope, whereas the signal across the resistor on Ch 2. (Fig.10.1). A frequency counter was used for the accurate measurements of the frequency output of the function generator. The applied peak-to-peak voltage was kept constant throughout the experiment at Vm=8V. The frequency of the AC voltage applied to the circuit varied from 100 kHz to 10 Hz . Assignments Read the lab manual, View the videos with the theory and experiments. Analyze each experiment and prepare the report in the following format: Name/ Names: Date: Title: Lab Objective: Write a short paragraph, in your own words, stating the objective of the laboratory. Equipment: Provide a sketch of the setup of the major pieces of equipment and their arrangement. Experimental Procedure: Summarize in a sentence or brief paragraph procedures, techniques, or methods used during the lab. Data & Analysis Describe the experimental setup and the measurement of the peak-to-peak input and output voltages, V,\" (on Ch.1 of the oscilloscope) and V0,\