13 16 points Chapter 5 On Table 1 below, place an X under the control that agrees with the statement to the left or "blank" if the control does NOT agree with the statement to the left. Table 1 Feature Feature of Size of Size H 1. For these controls, datums do not apply X A x x X X 2. For these controls, rule #1 applies X x B X X 3. These are surface controls X X X X 4. These controls may be specified with a leader C X X X 5. These are refinements of the size tolerance X X X X 6. These tolerances violate rule #1 X X 7. These controls apply to features of size D X X 8. These controls are associated with the dimension 9. These controls may exceed the size tolerance 10. The symbol may be used 11. The MMC (circle M) symbol may be used A. choose your answer... X E F X X G X X X B. choose your answer... C. choose your answer... D. choose your answer... E. choose your answer... F. choose your answer... G. choose your answer...