Question: 14. In a control system, the issues tied to electrical noise in a control cabinet would most affect (1 pt): a. High voltage wire b.

14. In a control system, the issues tied to electrical noise

14. In a control system, the issues tied to electrical noise in a control cabinet would most affect (1 pt): a. High voltage wire b. Low voltage wire

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

Q:

This streamer is very intense where the current varies between 1000 amps and 200,000 amps and the speed is about 10% that of light. With a particular number of towers the chances of incidence of...

Q:

With a particular number of towers the chances of incidence of lightning on power conductor scan be minimized by placing a ground wire at the top of the tower structure.. The tower presents a...

Q:

Once the stepped leader has made contact with the earth it is believed that a power return stroke(Fig. 1.6(c)) moves very fast up towards the cloud through the already ionized path by the leader....

Q:

The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground...

Q:

If it is low, the wave reflected back up the tower will largely remove the potential existing due to the incident wave. In this way the chance of flashover is eliminated. If, on the other hand, the...

Q:

We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground impedance (tower footing resistance) of the tower. If it is low, the...

Q:

The tower presents a discontinuity to the travelling waves; therefore they suffer reflections and refraction. The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the...

Q:

It is, therefore, desired that for good line design high surge impedances in the ground wire circuits, the tower structures and the tower footing should be avoided. High saturation induction (to...

Q:

The relay operating current (Io). The value of Io should not be too small or large so that the relay is either too sensitive or slow in responding. Damage to the equipment due to abnormally large and...

Q:

The sensitivity of a relay refers to the smallest value of the actuating quantity at which the relay operates detecting any abnormal condition. In case of an over current relay, mathematically this...

Q:

Determine the sample size necessary under the following conditions. a. To estimate with = 44, E = 3, and 95% confidence. b. To estimate with a range of values from 20 to 88 with E = 2 and 90%...

Q:

Consider the following events: a. The price of cell phones goes down by 25 percent during a sale. b. You get a 25 percent raise at your job. Which event represents a shift in the demand curve? Which...

Q:

A firm with high P / B ratio and low P / E ratio is likely to be a firm with d . Low current ROE and low expected growth in profitability b . High current ROE and high expected growth in...

Q:

Imperial Jewelers manufactures and sells a gold bracelet for $404.00. The companys accounting system says that the unit product cost for this bracelet is $270.00 as shown below: Direct materials $...

Q:

3. Can the employees demonstrate the correct knowledge or behavior? Perhaps employees were trained but they infrequently or never used the training content (knowledge, skills, etc.) on the job. (This...

Q:

6. Discuss the steps involved in conducting a task analysis.

Q:

8. Explain competency models and the process used to develop them.