Question: ( 2 0 ) For a given transfer function of a system G ( s ) = s 2 + 2 s + 1 0

(20) For a given transfer function of a system G(s)=s2+2s+10(s2+9s+20)(s+1)
a) Suppose that C(s) and R(s) are output and input of the system, respectively. Write relationship between the C(s) and R(s).
b) Write the differential equation between the input r(t) and the output c(t).
( 2 0 ) For a given transfer function of a system

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

2. (25) For a given transfer function of a system G(s) = 100 (s + (K+1)s+35)) (s+2)(s +4s+5) K=0 a) Find the differential equation between the input and the output of the system b) Find the unit step...

Q:

Consider the initial value problem ay" + by + cy=f(t), y(0) = y(0)=0, t> 0. Suppose that the transfer function of this system is given by (s) = 2+5+2 (a) What are the constants a, b, and c? (b) If...

Q:

1. (20) For a given transfer function of a system G(s) = 125 a) Find the poles and zeros of the system. b) Sketch zero-poles diagram in complex plane. c) Check the stability of the system....

Q:

Find Transfer Function G(s) Note: output various is "In(s). Current" R 15 2. (15 point) Determine the Transfer Function of the system that produced the following output in response to a unit step...

Q:

Short Answer Q 2 h - to Get the transfer function of Sink system and draw the block diagram

Q:

2) GUI design: Make the GUI design of the system that is given on the attach, by using the properties given below. a. Transfer function of the system is determined by the user. User must insert the...

Q:

undefined Q4. Figure (4) shows a second order system, G () that is controlled by a PD controller, G.(s). The control strategy is to use the following lead compensator, G.s), as equivalent to a PD...

Q:

The steering input controls the lateral motion of the vehicle (see Figure 1). The automated vehicle steering control system uses information about the vehicle position relative to the center of the...

Q:

For the single link robot arm system given in Figure 1 mass of the system is m, and length is 1. The angle between the robot and ground is 0. The angular velocity is . Control torque applied at the...

Q:

Tall let 0 = (t) [C] be the temperature of a graphics processing unit (GPU), a component of a computer. the computations performed by the GPU generate heat at a rate q=g(t) [J/s]. to prevent the...

Q:

With reference to the previous problem data, if changes in the inside diameter of the lined shaft are monitored for safety, what reading in inches would indicate impending failure of the liner?

Q:

Listed below are two sets of scores that are supposed to be heights (in inches) of randomly selected adult males. One of the sets consists of heights actually obtained from randomly selected adult...

Q:

Jack is buying an iPhone 2 0 at a local retailer. An employee tells Jack he also recommends purchasing an insurance plan to cover future damages. The employee is using a ( n ) _ _ _ _ _ _ _ _ _ _ _ _...

Q:

I need help to answer these questions. thanks in advance.... Part V - Balanced Scorecard & Performance Measurement (15 marks) 1. What are the six characteristics of a good performance measurement ...