$2.(7$ points$)$ Write a CNC program in G$-$code format for the part given below and attach a path simulation figure from the Simulation website or the NCPlotcom. Conduct the drilling cycle first and then the Milling cycle later.

Work piece Material: Carbon steel plate with $10$ mm thick.

Machine Tool: CNC vertical milling machine $($HAAS$)$

$-$ All dimensions are in millimeters

$-$ Use a $10$ mm twist drill for drilling holes $($T$01)$

$-$ Use a $10$ mm diameter Finish end mill cutter for contouring milling $($TO$2)$

$-$ Tool dimensions have been saved into the registers H$01$ and H$02$ respectively

$-$ Spindle speed at $900$ rpm with using the coolant

$-$ Feed rate in horizontal $\backslash (200\backslash$mathrm$\{$~mm$\}/\backslash$mathrm$\{$min$\}\backslash ).$ and in vertical $\backslash (75\backslash$mathrm$\{$~mm$\}/\backslash$mathrm$\{$min$\}\backslash )$

$-$ Use G$81$ and G$80$ for drilling

$-$ Use G$40$ for contour Milling