2. Program 2 a) Write a program in LogixPro for problem 2. The contacts R-1, R-2, F-1, and F-2 are not inputs and must be replaced with XIO and XIC instructions that are addressed to the F & R Motors. b) Once again, include YOUR initials in the symbol for EACH of the outputs. Save, download and test your program to verify that it works properly as the circuit would have worked. For example, only one output can be on at a time, and also verifying that the Fwd and Rev buttons start the correct output and then the output is sealed in by the use of the parallel instruction. Stop PB_1:1/0 Fwd PB_1:1/1 Rev PB_1:1/2 F_0:2/0 R 0:2/1 L1 L2 STOP Fwd R1 F2 Rev F1 2. Program 2 a) Write a program in LogixPro for problem 2. The contacts R-1, R-2, F-1, and F-2 are not inputs and must be replaced with XIO and XIC instructions that are addressed to the F & R Motors. b) Once again, include YOUR initials in the symbol for EACH of the outputs. Save, download and test your program to verify that it works properly as the circuit would have worked. For example, only one output can be on at a time, and also verifying that the Fwd and Rev buttons start the correct output and then the output is sealed in by the use of the parallel instruction. Stop PB_1:1/0 Fwd PB_1:1/1 Rev PB_1:1/2 F_0:2/0 R 0:2/1 L1 L2 STOP Fwd R1 F2 Rev F1