20. Demand management in JIT is handled through 3. the master b. production c. lead times d. flow times production smoothing scheduling module 21. Production smoothing complies with a. the master b. periodic c. lead times d. flow times production production scheduling quota module 22. The desire to maximize utilization is to return on the investment of the equipment. a. decrease o neutralize b. increase d. none of the above 23. The effect of maximizing utilization is to cycle times, a, decrease c. neutralize b. increase d. none of the above 24. For logistical reasons, we want to keep utilization levels manageable because it a. increases WIP c. more inventory b. more late jobs d. all of the above 24+ Cycle time reduction can reduce I a. WIP c. FGI b. raw materials d. all of the above Multiple Choice Identify the choice that best completes the statement or answers the question, 9. In a multiproduct reorder point subject to an aggregate service constraint, what will be the effect of increasing the cost of one of the parts on the fill rate of the part? a. Fill rate for that b. Fill rate for that c. Fill rate for that d. Fill rate for that part goes down part goes up part stays the part fluctuates same __b_10. In a multiproduct reorder point subject to an aggregate service constraint, what will be the effect of increasing the cost of one of the parts on the fill rates of the other parts? a. Fill rate for b. Fill rate for c. Fill rate for d. Fill rate for other parts other parts other parts other parts goes down goes up stays the same fluctuates Version A