$(30$ points$)$ Use SolidWorks $($SW$)$ FEA to apply a bending load of $600$ lbf on the right end of

the stepped shaft as shown below. This is the same geometry as Homework $1.$ Estimate stress

concentration factor $K_t$ for bending from your FEA. Provide a hardcopy color plot of your FEA

showing maximum von Mises stress.

$K_{t_{-}\text{b}\text{e}\text{n}\text{d}\text{i}\text{n}\text{g}}=\frac{{}_{FE{A}_{-}\text{b}\text{e}\text{n}\text{d}\text{i}\text{n}\text{g}}}{{}_{NOMINA{L}_{-}\text{b}\text{e}\text{n}\text{d}\text{i}\text{n}\text{g}}}$

$K_{t_{-}\text{b}\text{e}\text{n}\text{d}\text{i}\text{n}\text{g}}$