$3\mathrm{.}2.$ Configure OSPF

In this section, you will configure OSPF on R$1$ and R$2$ using these parameters:

$$ Configure OSPF using process id $100($one hundred$)$

$$ Use router ID:

o R$1$: $1\mathrm{.}1\mathrm{.}1\mathrm{.}1$

o R$2$: $2\mathrm{.}2\mathrm{.}2\mathrm{.}2$

$$ Suppress routing OSPF updates on GigabitEthernet$0/0$ interface on both routers

o There is no point in sending OSPF updates over the Gi$0/0$ interface since there are no other routers to process them.

$$ Using the network command, add all directly connected networks to OSPF area $0$

o The network address and the wildcard mask must match the network subnet exactly.

$3\mathrm{.}3.$ Verify connectivity