Question: A thermionic generator has a tungsten emitter heated to 2300 K and a cesium coated collector at 1000 K. Electrodes area is 200 cm.

A thermionic generator has a tungsten emitter heated to 2300 K and

A thermionic generator has a tungsten emitter heated to 2300 K and a cesium coated collector at 1000 K. Electrodes area is 200 cm. Under all cireumstances, the diode behaves as if it had an internal resistance of 10 mn. Disregard collector emission and thermoelectric effects. Assume there is no space charge. Use Table 6.1 and 1.2 for the values of the parameters. a) Calculate the highest possible output power. b) Calculate the load resistance that causes the device to furnish the highest possible output power.

Step by Step Solution

★★★★★

3.45 Rating (155 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

To solve this problem we need to consider a thermionic generator with a given internal resistance an... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

If an ammeter with an internal resistance of 100 and a current capacity of 2 mA is to measure 5 A, determine the value of the resistance needed. Calculate the power dissipated in the shunt resistor?

A battery with an internal resistance of 10.0 produces an open-circuit voltage of 12.0 V. A variable load resistance with a range from 0 to 30.0 is connected across the battery. (Note: A battery has...

An audio oscillator (ac source) with an internal resistance of 2000 and an open-circuit rms output voltage of 12 V is to be used to drive a loudspeaker with a resistance of 8 . What should be the...

Hello, you already did chapter 1 and 2 of my MASTERS Thesis already for me. (See attached) So normally you know masters thesis consist of 5 chapters right ??..... But in this case my thesis will be 4...

I need a Gantt chart or similar timetable briefly outlining what & when you will be doing, and more description on the process you will be following to complete these tasks. E.g. Pre-degradation...

PXT992 Research Project Plan Degradation Mechanisms in Quantum Dot on Silicon Lasers Author 1 Purpose (motivation) One of the most urgent issues in semiconductor technology is the direct development...

Possible Multiple Choice Questions for the Exam. Focus on the topics discussed in class. Chapter 1 Multiple Choice Identify the choice that best completes the statement or answers the question. ____...

BLC Inc. is a medium-sized manufacturing company based in the UK. The company operates mainly in the London area and is based in Peterborough. At a recent board meeting, the company decided to expand...

The case discusses the dilemma of the CFO of PSUWC Energy LLC, an energy generating firm, who needs to present his recommendation to the company Board regarding a proposed investment in a new...

Financial Impacts of Climate Change: Invest or Not? It was a sunny Friday afternoon in downtown Denver, CO, and Skylar Morrisoni was enjoying a muchneeded break in the common area of her venture...

Bonds with a stated interest rate of 8% and a face value totaling $525,000 were issued for $535,500 on January 1, 2018, when the market interest rate was 7%. The company uses effective-interest bond...

1. According to Kant, what are the benefits to the individual in exercising their reason? What are the benefits to society? 2. How might this understanding of the "freedom of reason" have been seen...

create a practice research question for which the collection of observational data will be appropriate. What are three observations you might make when conducting this research? How will these...

A pressure-fed monopropellant thruster has a 2 m propellant tank. The propellant tank is pressurized to 12 MPa by helium, which enters through a regulator that keeps the pressure in the propellant...

You are trying to learn whether a training program leads to higher post training wage rates. You compare the average wage rates for workers who went to training to the average wage rates for workers...

Cynthia uses hours to determine her internet use. Over a 4 week period in September, she used her internet for a total of 7 7 6 hours, of which 2 2 3 hours were used for work purposes. Her internet...

Kota Toy Corporation manufactures lizard dolls in two departments, first the Molding department and then on to the Assembly department. Kota uses a weighted-average process cost system. During...

A statistical study shows that the fraction of television sets of a certain brand that are still in service after x years is given by f (x) = e-0.15x. (a) What fraction of the sets are still in...

Use a statistical software package to simultaneously test all six hypotheses given at the beginning of this section. a. Submit the appropriate software output. b. Create a normal probability plot...

Use the data from Table 6.1 and define a benign cell as a success. Conduct a hypothesis test for the homogeneity of odds. a. State the null and alternative hypotheses. b. Calculate the odds ratio and...

Table 11.3 displays some of the work required to find the posterior probabilities for Ï. Find the missing entries in the table and find the remaining posterior probabilities. For this question,...

2.1. Explain the difference between (a) Discrete and continuous variables (b) Categorical and quantitative variables (c) Nominal and ordinal variables Why do these distinctions matter for statistical...

2.5. Which scale of measurement is most appropriate for "attained education" measured as (a) Number of years (0,1,2, 3,...) (b) Grade level (elementary school, middle school, high school, college,...

2.4. Which scale of measurement is most appropriate for (a) Occupation (plumber, teacher, secretary,...) (b) Occupational status (blue collar, white collar) (c) Social status (lower, middle, upper...