3. Flip-Flop: Consider the circuit design generated in Logisim. This circuit is composed from an IC that contains two D flip-flops. Connected to both flip-flops is a clock clk signal, and two specialized inputs named CLR' and PRE.Furthermore, the circuit contains an inpux 2/3 Tasks: 22. Identify the four differemt chips within Figure 1. 23 From the Logisim design shown in Figure 1, draw the equivalent circuit diagram, that consists of gates and flip-flops, Use the datasheet of each chip in the process of drawing. 24. Obtain the flip-flop input equations. 25. Obtain the state table of the circuit. 26. Draw the state diagram. 27. Copy figure 1 to Logisim and verify that your results are correct. 28 Save your work in a file under the name Lab3 3 X, where X corresponds to your ID number. 29. In the lab, call a lab supervisor to verify work CLR PRE CLKL Figure 1