3. Refer to Table $6.1 Factors for Computing Control Chart Limits (3 sigma) ? for this problem. Sampling 4 pieces of precisioncut wire (to be used in computer assembly) every hour for the past 24 hours has produced the following results: Hour R Hour R Hour R Hour R 3.25" 0.71" 3.05 0.53" 3.11" 0.85" 19 3.41" 1.61" 2 3.10 1.18 2.65 1.13 14 2.83 1.31 20 2.89 1.09 3 3.22 1.43 9 3.02 0.71 15 3.12 1.06 21 2.65 1.08 4 3.39 1.26 2.85 1.33 16 2.84 0.50 22 3.20 0.46 Ch 3.07 1.17 11 2.83 1.17 17 2.86 1.43 23 2.94 1.58 R 2.86 0.32 12 2.97 0.40 18 2.74 1.29 24 2.64 0.97 Based on the sampling done , the control limits for 3sigma x chart are round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL-) = inches (round your response to three decimal places). Lower Control Limit (LCL;) = inches (round your response to three decimal places). Based on the x chart, the wire cutting process has been (1) The control limits for the 3 sigma Rchart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL ) = inches (round your response to three decimal places). Lower Control Limit (LCLR) = inches (round your response to three decimal places). Based on the Rchart, the wire cutting process has been (2) 2: Definition