4. Is it possible to create a revolved surface with a start angle other than zero egrees? Yes No 5. A revolved surface can only be rotated 180 degrees? A. True False 6. Tool Containment specifies the behaviour of the containment boundary, Compensate to Outside does the following: A. Keeps the tool inside the boundary B. Keeps the tool centerline inside the boundary (allow up to half of the tool to exit the boundary) Allows the entire tool to exit the boundary but keeps the tool edge in contact with the boundary C. 7. The rough parallel toolpath removes stock quickly using multiple constant Z depth. A. True B. False 8. Surface High Speed Waterline also works at constant Z depth and steps down with cuts directly on the surface. A. True B. False 9. A closed chain of curves that limit tool motion is: A. Fillet Curve B. C-Hook C. Containment Boundary D. Surface Fillet Boundary 10. The Add cuts selection allows the user to add cuts in shallow areas to decrease the size of? A. Gouging B. Program length C. Surface scallops D. Fillet radii