$-4.)$ There are four runout controls on this part. Would the inspector be required to setup the part differently for each of the controls? Why or why not? $(6$ points$)$

$5.)$ As in question $\backslash$#$3$ above, describe how you would check the two circular runouts on the front view with only manual equipment. Again, be specific. What kind of readings would expect with the dial indicator? How do you know if it is acceptable or not? $(6$ points$)$

$6.)$ Same as question $\backslash$#$5$ above, but this time the total runout in the front view. $(6$ points$)$

$7.)$ We have taken readings on the four runout controls on this part. They are in the attached document titled Inspection of Runout Tolerances on Part $426.$DOCX. For the two circular runout controls, figure out the FIM for each measurement and list them in another word document titled WK$14-$initials.DOC. In this same document you must state the pass$/$fail status of each runout control. $(10$ points$)$