5 (1 point) Suppose you wish to compare two different 3D non-contact measurement devices (coded as MC A and MC B). For each device, you measure the same 21 different features (analyze these as units or parts). Among these features, 5 are cylinder diameters, 6 are circle diameters, and 10 are surface dimensions. All measurements are recorded as deviation from nominal (no tolerances are available). Conduct a Repeated Measurement Study using both a Fitted Line Plot and a Paired t-test (and any additional follow up analysis on their paired differences) to compare MC A and MC B measurements systems to answer the following. Which of the following would most likely be concluded? a. R-sq between devices (MC A vs. MC B) is greater than 95% and there is no significant difference between machines based on a paired t-test b. R-sq between devices (MC A vs. MC B) is less than 95% and there is a significant difference between machines based on a paired t-test. Then, as a follow up to the repeated measurement study, the largest differences between systems is for circle diameter measurements c. R-sq between devices (MC A vs. MC B) is less than 95% and there is a significant difference between machines based on a paired t-test. Then, as a follow up to the repeated measurement study, the largest differences between systems is for cylinder diameter measurements. d. R-sq between devices (MC A vs. MC B) is less than 95% and there is a significant difference between machines based on a