Question: 8051 microcontroller and embedded system Write a program to check a switch connected to PI.1. If the switch is on (the value is 1), create

8051 microcontroller and embedded system

Write a program to check a switch connected to PI.1. If the switch is on (the value is 1), create a rectangular wave of 10KHz of 66% (2/3) duty cycle on pin P1.2. Otherwise, send a character from RAM location 30H serially to a printer connected to the serial communication port of 8051. Baud rate=THI -3. XTAL=12MHZ Write a program to check a switch connected to PI.1. If the switch is on (the value is 1), create a rectangular wave of 10KHz of 66% (2/3) duty cycle on pin P1.2. Otherwise, send a character from RAM location 30H serially to a printer connected to the serial communication port of 8051. Baud rate=THI -3. XTAL=12MHZ

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

this is the full paper The 8051 has two timers/counters. They can be used either as timer to generate a time delay or as counters to count event happening outside the micro-controller. A pulse width...

After reviewing the PowerPoint on understanding financial statements and ratio analysis, create a narrated PowerPoint illustrating the financial health of your chosen organization. Your presentation...

Please answer the attached questions from the attached file Cisco Systems, Inc. 2014 Annual Report Annual Report 2014 Letter to Shareholders To Our Shareholders, When we look back on fiscal 2014, we...

8051 microcontroller and embedded system 8051 microcontroller and embedded system solve it using assmbly not c langauge Suppose a sensor is connected to INTO of the 8051. The 8051 is installed at the...

8051 microcontroller and embedded system Write a program with three subroutines to (a) transfer the following data from on-chip ROM to RAM locations starting at 30H, (b) add them and save the result...

a) (2 pts) Write a program to continually monitor P1.3 and output its status to P2.5. Do not use a conditional jump (branch) instruction. b) Write a program using XRL to continually toggle P1.2 and...

8051 microcontroller and embedded system Write a program that will read a sentence stored in ROM memory at address 3000H and count the number of the letter 'R' in that sentence. The sentence ends...

8051 microcontroller and embedded system Write a program that will read a packed BCD number from port 1. Then it will send the ASCII value of each digit to P2 and P3. Use a look-up table. The ASCII...

Homework #1 Q1. (Memory) Find the address and data pins for 256K x 8 RAM. Draw a block diagram showing the direction of address bus and data bus. Q2. (Embedded System) Draw a block diagram (and...

NOTE !! You must answer them all OR leave them to another Instructor. Be aware These multiple choices from class "8051 Microcontroller and Embedded Systems" Give direct answers! 23. What is the final...

Under the general transfer-pricing guideline, the minimum transfer price will vary depending on whether or not the supplying division has idle capacity. Do you agree? Explain.

Question 2 State true or false a. Resistance of a conductor decreases with increase in temperature. b. Resistor terminals have polarity marking on the body of the resistor. c. Electrolytic capacitor...

\ table [ [ , 2 0 0 8 , 2 0 0 9 ] , [ Total sales, 6 0 0 , 5 4 0 ] , [ Cost of sales, - 5 3 2 , - 4 8 8 ] , [ Gross Profit, 6 8 , 5 2 ] , [ Selling , general,,, ] , [ and administrative expenses, - 3...

Please use Java Using an inheritance hierarchy, design a Java program to model items at a library (books, journal articles, videos and CDs.) It is a simplified libray system with limited...

Strong understanding of technology and systems, and business process improvement

3. Describe how Great-Wests invoice approvals process changed after the mobile application was deployed.

13-5 What are new approaches for system building in the digital firm era?