8.For Spring mass damper system, m=1 Kg, k=1N/m, c=1/4 N.s/m, subjected to harmonic excitation force has...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
8.For Spring mass damper system, m=1 Kg, k=1N/m, c=1/4 N.s/m, subjected to harmonic excitation force has amplitude 2 N, and driving frequency = 4 rad/s, the value of steady state amplitude is: O a. 16/3 O b. 35/3 O c. 41/3 d. None of them 8.For Spring mass damper system, m=1 Kg, k=1N/m, c=1/4 N.s/m, subjected to harmonic excitation force has amplitude 2 N, and driving frequency = 4 rad/s, the value of steady state amplitude is: O a. 16/3 O b. 35/3 O c. 41/3 d. None of them
Expert Answer:
Related Book For
Posted Date:
Students also viewed these physics questions
-
Consider the diode bridge rectifier shown below with the voltage regulating capacitor in parallel with the load resistor. 60Hz 120V 10:1 C-470F IL R=1kQ a) For the input signal, sketch waveforms of...
-
The current amplitude I versus driving angular frequency w d for a driven RLC circuit is given in Figure, where the vertical axis scale is set by I s = 4.00 A. The inductance is 200H, and the emf...
-
What is the shear capacity of the RC beam described below considering the steel reinforcement and using the formula: VRsyAw 2fyd cot 8/s The shear reinforcement in the beam is provided by sets of...
-
Differentiate implicitly to find 2x + 5xy + 5y +16y - 8 = 0; dy dx . Then find the slope of the curve at the given point. (-2,0)
-
Gray, Inc., a private foundation, reports the following items of income and deductions. Gray is not an exempt operating foundation, and it is not eligible for the 1% tax rate. Interest income $...
-
An article in the International Journal of Clinical Practice described a study in which a sample of 314 patients took a combination of the drugs ezetimibe and simvastatin in order to reduce their...
-
On its books, Navarro Companys Cash account shows an ending balance of \($770\). The bank statement for the current period shows a \($20\) service charge and an NSF check for \($100.\) A \($250\)...
-
Consider two Bertrand competitors in the market for brie, Francois and Babette. The cheeses of Francois and Babette are differentiated, with the demand for Francois' cheese given by qF = 30 - pF +...
-
Question: Note:Minimum Of 300 Words Per Question What Is The Difference Between Primary And Secondary Data? When Should You Note:Minimum of 300 words per question What is the difference between...
-
a. To simplify the analysis, assume for now that there is virtually no turnaround time between flights so the next flight can begin as soon as the current flight ends. (If an immediate next flight is...
-
A company without debt has a WACC of 8%. The firm decides to go into debt at a rate of 5% to the tune of 33.3% (one third) of its value in order to finance a capital reduction of a similar amount....
-
What provider incentives are created under (a) cost-based reimbursement, (b) prospective payment, (c) capitation?
-
Why must a finance book consider taxes?
-
What are the two primary ways that costs can be classified?
-
How does a benefit corporation (B corporation) differ from a traditional for-profit corporation?
-
What are two different types of MCOs?
-
1) Draw the condensed or skeletal structural formulas for the following alcohols. Identify each as primary, secondary, or tertiary, and predict if they are soluble, slightly soluble or insoluble in...
-
Select a mass spectrometric technique with the highest mass resolution for identifying an unknown compound being eluted from a liquid chromatography column
-
An a particle (charge +2e) and a b particle (charge -e) deflect in opposite directions when they pass through a magnetic field. Which particle deflects by a greater amount, given that both particles...
-
Object 1 has a mass m 1 and a velocity v(vector) 1 = (2.80 m/s)x. Object 2 has a mass m 2 and a velocity v(vector) 2 = (3.10 m/s)y. The total momentum of these two objects has a magnitude of 17.6 kg ...
-
Express the angular velocity of the second hand on a clock in the following units: (a) rev/h, (b) deg/min, (c) rad/s.
-
If the bearing pads at \(A\) and \(B\) support only vertical forces, determine the greatest magnitude of the uniform distributed loading \(w\) that can be applied to the beam. \(\sigma_{\text {allow...
-
The beam is constructed from two boards. If each nail can support a shear force of \(200 \mathrm{lb}\), determine the maximum spacing of the nails, \(s, s^{\prime}\), and \(s^{\prime \prime}\), to...
-
The simply supported beam is composed of two W12 \(\times 22\) sections built up as shown. Determine the maximum uniform loading \(w\) the beam will support if the allowable bending stress is...
Study smarter with the SolutionInn App