Question: A 2 0 8 V , 1 0 hp , four pole, 6 0 Hz , Y - connected induction motor has a full -

A 208 V,10 hp, four pole, 60 Hz, Y-connected induction motor has a full-load slip of 5 percent.
What is the synchronous speed of this motor. What is the rotor speed of this motor at the rated
load.
What is the rotor frequency of this motor at the rated load. What is the shaft torque of this motor
at the rated load.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Question 1: A single-phase, full-bridge diode rectifier fed from a 230 V, 50 Hz sinusoidal source supplies a series combination of finite resistance, R, and a very large inductance, L. The two most...

Q:

Discuss they types of formal organisation of communication and explain the general purpose of each type. 5.Explain the terms operational management as well as major managerial activities involved in...

Q:

1.What is organisational communication? 2.How important is communication to mangers? 3. List and describe micro and macro barriers of effective communication 4.Discuss they types of formal...

Q:

A 400V, 4-pole, 50 Hz, 3-phase, 10 hp, star connected induction motor has a no load slip of 1% and full load slip of 4%. Find the following: (i) Syn. speed (ii) no-load speed (iii) full-load speed....

Q:

Question 1: The flux per pole in a synchronous motor with the field circuit ON and the startor disconnected from the supply is found to be 25 mWb. When startor is connected to the rated supply with...

Q:

1.Sketch a line diagram to the types of business organisation on the basis of ownership 2.What do you understand by joint sector companies? Mention the diagrams for the formation of joint sector...

Q:

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

Q:

1.Sketch a line diagram to the types of business organisation on the basis of ownership 2.What do you understand by joint sector companies? Mention the diagrams for the formation of joint sector...

Q:

please answer all the questions:- A wound DC motor is connected in both a shunt and a series configuration. Assume generic resistance and inductance parameters Ra, Rf, La, Lf, let the field...

Q:

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

Q:

Two matched LDRS are used in the circuit below with R versus I, as shown on the figure. 15V 15V Vin > v LOR va SCC 5V Compe LEGRED 10- Design a signal conditioning circuit that: > Gives Vout%3D0...

Q:

Why is identification of the real problem the first and most important step in the decision-making process? How does attribution theory explain mistakes that can be made as managers and employees...

Q:

Should Vestas continue to expand in China despite its small share of a big market, or should focus on other markets and why?

Q:

Required information P6-1 (Algo) Reporting Net Sales and Expenses with Discounts, Returns, and Bad Debts LO6-1, 6-2 [The following information applies to the questions displayed below.] The following...