Question: (a) A spring-mass system with m = 0.5kg and k = 10,000 N/m, with negligible damping, is used as a vibration pickup. When mounted

(a) A spring-mass system with m = 0.5kg and k = 10,000 N/m, with negligible damping, isused as a vibration pickup. When moun

(a) A spring-mass system with m = 0.5kg and k = 10,000 N/m, with negligible damping, is used as a vibration pickup. When mounted on a structure vibrating with an amplitude of 4 mm, the total displacement of the mass of the pickup is observed to be 12 mm. Find the frequency of the vibrating structure. (a) A spring-mass system with m = 0.5kg and k = 10,000 N/m, with negligible damping, is used as a vibration pickup. When mounted on a structure vibrating with an amplitude of 4 mm, the total displacement of the mass of the pickup is observed to be 12 mm. Find the frequency of the vibrating structure.

Step by Step Solution

★★★★★

3.50 Rating (170 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

mars stiffness z 10000 Nm Ratial displacement 4mm Total displacemen... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

A spring-mass system with m = 0.5 kg and k 10,000 N/m, with negligible damping, is used as a vibration pickup. When mounted on a structure vibrating with an amplitude of 4 mm, the total displacement...

The 0.5-kg mass shown in Figure P13.1 is attached to the frame with a spring of stiffness k = 500 N/m. Neglect the spring weight and any damping. The frame oscillates vertically with an amplitude of...

An electric motor, having an unbalance of 2 kg-cm, is mounted at the end of a steel cantilever beam, as shown in Fig.below. The beam is observed to vibrate with large amplitudes at the operating...

If the load cell of Problem 1 is assumed to be a second-order system with negligible damping, determine the practical frequency range over which it can measure dynamic loads with an inherent error of...

Consider the transmission of a sinusoid x(t) = cos(2f0t) through a channel affected by multi-path and Doppler. Let there be two paths, and assume the sinusoid is being sent from a moving object so...

A certain resonance curve describes a mechanical oscillating system with logarithmic damping decrement = 1.60. For this curve find the ratio of the maximum displacement amplitude to the displacement...

In Problem 47, Chapter 9, a steam-driven turbine governor system was implemented by a unity feedback system with a forward-path transfer function (Khodabakhshian, 2005) a. Use a sampling period of T...

The unit-step response of a plant is shown in Figure 10.46. a. The lag time $L$ and the reaction rate $R$ can be determined from the figure. Find the P, PI, and PID controller parameters using...

A 10-kg mass is connected to a spring of stiffness $3000 \mathrm{~N} / \mathrm{m}$ and is released after giving an initial displacement of $100 \mathrm{~mm}$. Assuming that the mass moves on a...

Deer Lake Inc. uses a job order costing system with manufacturing overhead applied to products at a rate of 150% of direct labor cost. Treating each case independently, find the missing amounts Case...

The Minitab output displayed here is the result of a multiple regression analysis with three independent variables. Variable x1 is a dummy variable. Discuss the computer output and the role x1 plays...

How would our world be different if the vast majority of people could not use a specific sense such as sight, hearing, taste, or smell? Choose one of these and reflect on how society as a whole would...

Determine y ' ( x ) if y ( x ) = ( x 4 x 3 ) 1 x . Select the correct answer below: y ' ( x ) = - 1 x 2 ( l n ( x 4 x 3 ) ) ( x 4 x 3 ) 1 x y ' ( x ) = ( x 4 x 3 ) 1 x ( - 1 x 2 l n ( x 4 x 3 ) ( 4 x...

The following transactions of Jasmine Reef occurred during 2018: Apr. 30 Reef is party to a patent infringement lawsuit of $190,000. Reef's attorney is certain it is remote that Reef will lose this...

A seven-year, $10 000 promissory note bearing interest at 8% compounded quarterly is discounted four years after the date of issue at 7% compounded semi-annually. What are the proceeds of the note?

Mullineaux Corporation has a target capital structure of 70 percent common stock and 30 percent debt. Its cost of equity is 11.5 percent, and the cost of debt is 5.9 percent. The relevant tax rate is...

A ten-year promissory note for $1750 dated May 1, 2013, bearing interest at 4% compounded semi-annually is discounted on August 1, 2019, to yield 6% compounded quarterly. Determine the proceeds of...

Find the proceeds of a non-interest-bearing promissory note for $75 000 discounted 42 months before maturity at 6.5% compounded semi-annually.

how would i find out how to factor this Chrome Edit View History Bookmarks Profiles Tab Window Help 28% Thu 4:14 PM Q IE Access denied | delaGATE x | (_ Section 1.2: Alexis Ortiz X P Do Homework -...

A spring-mass system with $m=0.5 \mathrm{~kg}$ and $k=10,000 \mathrm{~N} / \mathrm{m}$, with negligible damping, is used as a vibration pickup. When mounted on a structure vibrating with an...

> A spring-mass system is a fundamental concept in physics and engineering that describes the dynamic behavior of a mass attached to a spring. This system is commonly used to model and analyze...

Need part a Computer 13. Consider ~ [ ] the spring-mass system in Figure 4.4 (a simple model of a short poly- mer molecule). The blocks are free to move but only along the r-axis. The springs...

matlab code. This question is based on (but is not identical to) exercise 13 on page 121 of the textbook. This problem models a short polymer molecule (Figure 4.4 on page 121) as a system of springs...

please write code on Matlab using Gauss Siedel Method. spring system is provided A06.1 Spring mass system with Gauss-Seidel 15 marksl Consider a spring-mass system similar to the one discussed in...

Create matlab script file for the following challenge problem, please show code with comments and figures ! Challenge 3: Spring-mass system (t) k, *1 Consider the spring-mass system in the above...